Installation
Installation
STEP 4 Adjust the levelling feet
Level the refrigerator by manually adjusting the levelling feet. Turn the levelling feet clockwise to lower the position, or turn counter clockwise to raise. For safety reasons, adjust the front side a little higher than the rear side.
Leave the feet at 66 mm (A) from the floor as shown.
A
STEP 5 Initial settings
By completing the following steps, the refrigerator should be fully functioning.
1.Plug the power cord into the wall socket to turn the refrigerator on.
2.Open the door, and check if the interior light lights up.
3.Set the temperature to the coldest, and wait for about an hour. Then, the freezer will be slightly chilled, and the motor will run smoothly.
4.Wait until the refrigerator reaches the set temperature. Now the refrigerator is ready for use.
STEP 6 Final check
When installation is complete, confirm that:
•The refrigerator is plugged into an electrical outlet and grounded properly.
•The refrigerator is installed on a flat, level surface with a reasonable clearance from the wall or the cabinet.
•The refrigerator is level and is sitting firmly on the floor.
•The door opens and closes freely, and the interior light turns on automatically when you open the door.
30 English
1/11/2018 2:47:44 PM
