•Disconnect front links from deck by removing retainer springs.
•Raise lift lever to raise suspension arms. Slide mower out from under tractor.
IMPORTANT" If an attachment other than the mower deck is to be mounted on the
tractor, remove the front links and hook the clutch spring onto square hole in frame.
TO INSTALL MOWER
•Raise attachment lift lever to its
highest position.
° Slide mower under tractor with discharge guard to right side of tractor.
•Lower lift lever to its lowest position.
•Install mower in reverse order of removal instructions.
TO LEVEL MOWER HOUSING
Adjust the mower while tractor is parked on level ground or driveway. Make sure
tires are properly inflated (See "PROD-
UCT SPECIFICATIONS section of this
manual). If tires are over or underinflated, you will not properly
adjust your mower.
SIDE-TO-SIDE ADJUSTMENT
•Raise mower to its highest position.
•At the midpoint of both sides of mower, measure height from bottom edge of
mower to ground. Distance "A" on both sides of mower should be the
same or within 1/4" of each other.
•If adjustment is necessary, make adjustment on one side of mower only.
•To raise one side of mower, tighten lift link adjustment nut on that side.
•To lower one side of mower, loosen lift
link adjustment nut on that side. NOTE: Each full turn of adjustment nut will change mower height about 1/8".
• Recheck measurements after adjust-
ing. |
|
Bottom edge of | Bottomedge of |
mower to | mower to |
ground _ | ground |
Ground Line |
adjustment is necessary, be sure to adjust both front links equally so mower will stay level
To obtain the best cutting results, the mower housing should be adjusted so that the front is approximately 1/8" to 1/2" lower than the rear when the mower is in its highest position.
Check adjustment on right side of tractor. Measure distance "D" directly in front and behind the mandrel at bottom edge of mower housing as shown.
•Before making any necessary adjust- ments, check that both front links are equal in length. Both links should be approximately
•If links are not equal in length, adjust one link to same length as other link.
•To lower front of mower loosen nut "E"
on both front links an equal number of turns.
•When distance "D" is 1/8" to 1/2" lower at front than rear, tighten nuts "F" against trunnion on both front links.
•To raise front of mower, loosen nut "F" from trunnion on both front links. Tighten nut "E" on both front links an equal number of turns.
•When distance "D" is 1/8" to 1/2" lower at front than rear, tighten nut "F" against trunnion on both front links.
•Recheck
'D" "D"
Both Front Links Should be Equal in Length
n Arm | =E" |
Lift Link _
Adjustment Nut _
22 | Front Links |
