|
| F._ver |
| Knob |
| |
Air Cle_ |
|
| _,_g | Nut | ||
Cover | ( | _ |
| |||
Foam_ |
|
| _ |
| ) Grommet | |
Pre- | _ |
| / |
| ||
Cleaner• |
| X.. | [_, | _J_<Air Cleaner | ||
.. | • | _ |
|
| Paper | Cartridge |
| Cleaner | |||||
._ | _9_k'Base |
| ||||
_screen | _ .... | _J_ |
| |||
|
|
| Oil | Fil Cap/ | ||
| ._- | _ |
| Dipstick |
| |
('_ _jOil Drain
fPlug
CLEAN AIR SCREEN
Air screen must be kept free of dirt and chaff to prevent engine damage from
overheating. Clean with a wire brush or compressed air to remove dirt and stubborn dried gum fibers.
CLEAN AIR INTAKE/COOLING
AREAS
To insure proper cooling, make sure the grass screen, cooling fins, and other external surfaces of the engine are kept clean at all times.
Every 100 hours of operation (more often under extremely dusty, dirty conditions), remove the blower housing and other cooling shrouds. Clean the cooling fins and external surfaces as necessary.
Make sure the cooling shrouds are reinstalled.
NOTE: Operating the engine with a blocked grass screen, dirty or plugged
cooling fins, and/or cooling shrouds removed will cause engine damage due
to overheating.
AIR FILTER
Your engine will not run properly using a dirty airfilter. Clean the foam pre- cleaner after every 25 hours of operation or every season. Service paper car- tridge every 100 hours of operation or
every season, whichever occurs first. Service air cleaner more often under
dusty conditions.
•Remove knob and cover.
•Remove wing nut and air cleaner from base.
TO SERVICE PRE-CLEANER
•Slide foam
•Wash it in liquid detergent and water.
•Squeeze it dry in a clean cloth. Allow it to dry,
•Saturate it in engine oil. Wrap it in clean, absorbent cloth and squeeze to remove excess oil.
TO SERVICE CARTRIDGE
•Replace a dirty, bent, or damaged cartridge.
NOTE: Do not wash the paper cartridge or use pressurized air, as this will
damage the cartridge.
•Reinstall the
•Reassemble air cleaner, wing nut, cover and tighten knob securely.
ENGINE OIL FILTER
Replace the engine oil filter every
season or every other oil change if the tractor is used more than 100 hours in
one year.
•Drain oil from engine crankcase (See "TO CHANGE ENGINE OIL" in this
section of this manual, through step remove drain plug).
•Remove oil filter and wipe off filter adapter.
•Apply a thin coating of new engine oil to the rubber gasket on replacement oil filter.
•Install replacement oil filter on filter adapter. Turn oil filter clockwise until rubber gasket contacts the filter
adapter, then tighten filter an addi- tional 1/2 turn.
•Fill crankcase with new oil (See "TO CHANGE ENGINE OIL" in this section
of this manual). For approximate
capacity see "PRODUCT SPECIFICA- TIONS"section of this manual.
•Start the engine and check for oil leaks. Correct any leaks before placing engine into full operation.
Oil Filterf
MUFFLER
Inspect and replace corroded muffler
and spark arrester (if equipped) as it could create a fire hazard and/or
damage.
SPARK PLUGS
Replace spark plugs at the beginning of each mowing season or after every 100 hours of operation, whichever occurs
first. Spark plug type and gap setting are shown in =PRODUCT SPECIFICATIONS"
2O section of this manual,
