ŝ59Ş

Start up sound

Shutter sound

Important notes

ƈYou can select the sound that is activated whenever the camera is turned on.
ƃStart up sound : [Off], [Sound 1], [Sound 2], [Sound 3]
- If the start up image is set to [Off], the start up sound
will not activate, even though you may have set
these to on.
ƈYou can select the shutter sound.
ƃShutter sound : [Off], [Sound 1], [Sound 2], [Sound 3]
MYCAM
Start Image
Start Sound
Shutter Sound
Off
Sound 1
Sound 2
Sound 3
Back:
Set:OK
MYCAM
Start Image
Start Sound
Shutter Sound
Off
Sound 1
Sound 2
Sound 3
Back:
Set:OK
Be sure to observe the following precautions!
ƈThis unit contains precision electronic components. Do not use or store this unit
in the following locations.
- Areas exposed to severe changes in temperature and humidity.
- Areas exposed to dust and dirt.
- Areas exposed to direct sunlight or the inside of a vehicle in hot weather.
- Environments where there is high magnetism or excessive vibration.
- Areas with high explosives or highly flammable materials.
ƈDo not leave this camera in places subject to dust, chemicals (like naphthalene
and mothball), high temperature and high humidity.
Keep this camera with silica gel in a hermetically sealed box when not planning
to use the camera for a long period of time
ƈSand can be particularly troublesome to cameras.
- Do not let sand get inside the camera when using it on beaches, coastal
dunes, or other areas where there is lots of sand.
- Doing so may result in failure or may permanently render the camera unusable.
ƈHandling the camera
- Never drop the camera or subject it to severe shocks or vibrations.
- Protect the large size LCD monitor from an impact. When this camera is not
used, keep it in the camera case.
- Avoid obstructing the lens or the flash when you capture an image.
- This camera is not waterproof.
To avoid dangerous electrical shocks, never hold or operate the camera with
wet hands.
- If you use this camera in wet places, such as beach or pool, do not let water or
sand get inside the camera. Doing so may result in failure or may permanently
damage the unit.