Samsung SAM-14MV manual Location And Operation Of Controls

LOCATION AND OPERATION OF CONTROLS

1. CONTRAST/ BRIGHTNESS

After press this button, adjust the CONTRAST/BRIGHTNESS control for the desired overall display by press vol-( ) and vol+( ) buttons.

2. COLOR/ TINT

After press this button, adjust the COLOR control to set the color saturation level and TINT control for the proper color phase or flesh tones by press vol-( ) and vol+( ) buttons.

3. UNDER SCAN

Press the button, select the desired display size which over scan and under scan.

4. VOLUME -

Adjust the VOLUME control for the desired audio level and use for adjustment of the others button.

5. VOLUME +

Adjust the VOLUME control for the desired audio level and use for adjustment of the others button.

6. VIDEO 1 TACT SWITCH

Set the switch to VIDEO 1 if the camera jack is used.

7. VIDEO 2 TACT SWITCH

Set the switch to VIDEO 2 if the camera jack is used.

8. S-VIDEO TACT SWITCH

Set the switch to S-VHS if the S-VIDEO jack is used.

9. POWER SWITCH

Press to turn the monitor ON. The POWER LAMP above the switch will illuminate.

10. POWER LED LAMP

Power lamp indicates the power is on.

11. AC INLET

Use 100-240V AC, 50/60 Hz.

To prevent electrical shocks and fire hazards, do not use any other power source.

12 15. VIDEO INPUT & OUTPUT CONNECTORS

These BNC connectors permit looping of a video signal in those installations where it is desirable to dis- play the video signal on more than one monitor. A standard 1.0 Vp-p video signal applied to the VIDEO INPUT will also appear at the VIDEO OUTPUT. Use coaxial cables with BNC type plugs for these con- nections.

16. S-VIDEO JACK

If the camera or other video source outputs an S-VIDEO signal, connect it directly to this jack.

17 22. AUDIO INPUT & OUTPUT CONNECTORS

Connect an RCA cable between these jacks and the audio output jack of a camera or VCR.

4