ENGLISH
59
Playing back a Tape
Adjusting the LCD
The LCD control in PLAYERmode is identical to step 3 of page 30, except the power switch must be
set to PLAYERmode.
The speaker is turned ON/OFF by opening/closing the LCD.
The speaker ON/OFF setting operates when the LCD is opened. When it is set to OFF, the speaker
wont turn on even after opening the LCD.
1. Set the power switch to PLAYER mode.
2. Press the MENU ON/OFF button, then the MENU list will appear.
3. Turn the UP/DOWN dial to SPEAKER.
4. Press ENTER to switch the selection.
5. Press the MENU ON/OFF button again to end
the SPEAKER setting.
Volume control
Speaker volume can be controlled by turning
the MENU dial during playback.
Note: When the MENU list is on, volume will not be changed.
Setting the Speaker ON/OFF
LCD ADJUST
SPEAKER..............ON
PALCONV..............ON
DISPLAY................OFF
C.RESET................0:00:00
LCD ADJUST
SPEAKER..............OFF
PALCONV..............ON
DISPLAY................OFF
C.RESET................0:00:00
DSE in PLAYER mode
The procedure for using DSE in PLAYER mode is the same as the procedure for using DSE in
CAMERAmode, except that the power switch must be set to PLAYER instead of CAMERA.
Please refer to pages 44 and 45.
Note: The GHOST, STROBE, NEG., MIRROR, MOSAIC, CINEMAand WIDE(16:9) effects will not
operate when your camcorder is in PLAYER mode.
Pressing the DSE button will scroll through the available settings.
Stop at the one you require.