Installation
Installation
Notes
•The installation should be done by qualified service personnel or system installers.
•If the ceiling material is not strong enough to hold the installation screws, the camera may fall off. Reinforce the ceiling as needed.
•Take care not to drop the product during installation. Do not allow anyone to stand below the installation area.
1)Remove the dome cover and shield case from the main body by loosening the three dome cover screws.
Mounting Bracket
Main Body(Camera) |
Dome Cover
2) And then remove the main body from the mounting bracket by the four main body screws.
Adjust the panning, tilting and rotate mechanism while checking the position on the monitor
| 73° |
145° | 195° |
170° | Rotate Base |
| Tilt Base |
Pan Base |
|
|
1)You can adjust camera to any direction by using Pan, Tilt, Rotate mechanism.
•Pan Base moves by 170° to each direction and 340° on the whole.
•Tilt Base covers total 146° angle(73° to each side).
•The angle range of the Rotate Base is the same as that of the Pan Base.But one direction range is 195° and another is 145°
2)Methods of adjustment
•Wall installation
After mounting the camera to the wall, loosen the rotate base holding screws.
Adjust to the correct panning angle.
Then adjust the tilt angle by rotating the base.
Once complete
•Ceiling installation
After mounting the camera to the ceiling, loosen the rotate base holding screws.
Adjust to the correct panning angle.
Then adjust the tilt angle by rotating the base.
Once complete
Notes
•When adjusting the rotating angle, loosen rotate base holding screw as follows Figure A. And then tighten it again.
•When adjusting the tilting angle, grip the tilt base and adjust tilting angle.
•When adjusting the panning angle, loosen pan base holding screws as the follows Figure B. And then tighten them again.
•The 2 LED sections can be tilted inside the case to a maximum angle of 73°, this however will not alter the illuminated range.
Rotate Base Holding Screw
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Pan Base Holding Screw | Rotate Base Holding Screw | |||||
• When adjusting the tilt mechanism hold the Tilt base and NOT the lens.
COLOR DOME CAMERA 10 User Guide | COLOR DOME CAMERA 11 User Guide |
