ENGLISH
76
Installing the COMBO DriveConnecting the Cables
To install your COMBO drive in the PC, proceed as follows.
1
Make sure that the PC is powered off and disconnected from any power source.
1

Connecting the power cable

The 4-pin power cable from the internal power unit of your computer must be
connected to the power terminal on the rear of the COMBO drive.
Note:An improperly connected power cable may cause trouble. Check the direction of
the power connector and the incline side of the COMBO drive before connecting.
Cut side
2

Connecting the IDE cable

Insert the IDE cable (40-pin), which is connected to the hard disk to the interface
terminal. (Place the red line of the cable close to the Pin 1.)
Connect the cable to the SL (Slave) of the Master/Slave Select Terminal at
the rear of the COMBO drive.

When using one E-IDE cable

When using two E-IDE cable

2
If necessary, attach a horizontal bracket to
both sides of the drive.
Use of the brackets depends on your computer model;
you can purchase these accessories separately from
your computer dealer.
3
Remove the cover from a free expansion slot
and install the COMBO drive,
as shown in the illustration.
If you have no free expansion slot,
install the drive in place of the
diskette drive.
Power cable
E-IDE cable
Master/slave select terminal
Audio cable
Pin 1
Key Slot
Red Line
HDD
Slave Drive (Choose the SL Jumper)
Motherboard
COMBO Drive
cover
If there is only one COMBO drive, select MA (Master).
HDD
Master Drive (Choose the MA Jumper)
Master Drive (Choose the MA Jumper)
Slave Drive (Choose the SL Jumper)
SEC 1
PRI1
Motherboard
If there is two COMBO drive, select MA (Master) / SL (Slave).
HDD
(Choose the MA jumper) (Choose the SL jumper)
SEC 1
PRI1
Motherboard
+12V DC
Ground
Ground +5V DC