4) Installing the PIR Camera (SMM-PIRCAM)
1.Choose an installation site that can sufficiently support 5 times the weight of the equipments to be installed.
2.Remove the screw (BH M2.6) at the bottom of the main unit by turning it counterclockwise, and then lift the assy-case front as you push it upward to detach it from the case-rear.
(❊ Do not apply excessive force, as doing so may damage the inside assembly.❊)
Assy-case front
Screw (BH M2.6)
CASE-REAR
3.Place the case-rear over the installation site and mark screw holes with a pencil (indicated by the circles in the illustration). Drill a pilot hole for each pencil mark (5mm in diameter and at least 35mm in depth), and then fully insert the supplied plastic anchors (HUD 5) into them.
