Samsung SNC-L200P manual Network Configuration

Smart Viewer Administration Menu

Service	This is where to configure whether using this Service or not.
	Selecting “Enable” will allow you to use “Alarm Notification” function.
SMTP server	It means Simple Mail Transfer Protocol (SMTF) Server address.
	This address is used to transfer E-mails.
address
	Enter the after @ part of the Email Address you use.
Authentication Login	It is recommended to select “Enable.”
User ID / Password	When using the Authentication Login, enter User ID and User
	Password of the sender’s Email Address. They are usually
	designated at the time the mail service is subscribed.
Sender (E-mail)	Enter the sender’s Email Address.
	Do not use a bogus name because the mail server often check it to
	block Spam mails.
E-mail address 1~4	Up to 4 Email Addresses can be registered to receive video data.
Image Count	Up to 5 images can be sent with a 0.5-second interval each. The
	number of image count will be shown.

Assuming the sender’s Email Address is “inyoung.heo@samsung.com,” and the Password is “1234567,” the “Alarm Notification” should be configured as follows.

36

Smart Viewer Administration Menu

5.2 Network Configuration

Perform general network configuration. If network configuration is not done properly, you cannot to transfer images via Internet Explorer or configure Netcam on the web. Please ask your network administrator and enter the following setup information correctly. To apply the settings to Netcam, you must click “Apply” button.

Network Configuration	This is the menu to set “Static IP” or “DHCP.”
PPPoE(ADSL)	This is the menu to set PPPoE (ADSL).
Network Ports	This is the menu to set “HTTP Port.“
View Network Status	This is the menu to view current system network status.
Network Status	This is the menu used to notify the information of IP Address
Notification	that is dynamically allocated, such as DHCP or PPPoE.
DDNS Configuration	This is the menu used to set DDNS.

37

Video Netcam SNC-L200 Video Netcam SNC-L200