When cleaning the product, disconnect the power cord and clean the product with a soft dry cloth.
•Avoid using chemicals such as wax, benzene, alcohol, thinner, mosquito- repellent, fragrance, lubrication or cleansing agent when cleaning the product.
This may result in the exterior being deformed or the print being removed.
When not using the product for a long time, such as leaving your home, unplug the power cord from the wall outlet.
•Otherwise, it may cause dust accumulation and result in fire caused by overheating or a short circuit or result in an electric shock.
If the product is installed in a location where the operating conditions vary con- siderably, a serious quality problem may occur due to the surrounding environment. In this case, install the product only after consulting our Call Center.
•Places exposed to microscopic dust, chemicals, too high or low temperature, high humidity, such as airports or stations where the product is continuously used for a long time etc..
If you drop the product or the case is dam- aged, turn the power off and unplug the power cord. Contact a service center.
•Failing to do so may result in fire or electric shock.
Make sure to place your remote control on a table or desk.
•If you step on the remote control, you may fall and hurt yourself or the product may be damaged.
To avoid burning yourself, do not touch the vents or lamp cover while operating or right after turning off the product.
Do not open any cover on the product.
•This would prove hazardous because of
Be careful not to touch the ventilation hole while the projector is on as hot air comes out.
When a gas leak occurs, do not touch the product or the power plug and ventilate immediately.
•A spark may result in an explosion or fire.
•During a thunder or lighting storm, do not touch the power cord or antenna cable
Do not touch the lens on the product.
•This may cause damage to the lens.
Do not touch any outer part of the product with tools such as a knife or a hammer.
To clean dirt or stains on the front projec- tion lens, use spray or a wet cloth damp- ened with neutral detergent and water.
Ask a Service Center to clean the interior of the projector at least once per year.
Do not clean the product using water spray or a wet cloth. Avoid using any chemicals such as detergents, industrial or automo- tive polish, abrasive, wax, benzene, alco- hol on any plastic part of the product such as projector case, since this may cause damage.
Do not use any undesignated battery.
The ventilation hole is hot for some time though the projector is turned off. Keep you hands or body off the ventilation hole.
Major Safety Precautions |
