Samsung SP-H710AE : Turned On, : Flashing, : Turned Off, Preparation, Indicator Information, Accessories and Projector, Clearing Indicator Problems, POWER, POWER, POWER, State

Indicator Information

: Turned On	: Flashing	: Turned Off
TEMP LAMP	STANDBY	Information

If you press the POWER button on the remote control or projector, the screen appears within 30 seconds.

The projector is in normal operating condition.

The projector is warming up after POWER button has been pressed.

The POWER button is pressed to turn off the projector, and the cooling system is in operation to cool off inside of the projector. (Lasts for about 1 minute and 30 seconds)

Refer to measure 1 below if the cooling fan inside the projector is not in normal operation condition.

Refer to measure 2 below if the lamp cover protecting the lamp unit is not closed properly.

Power is turned off automatically when temperature inside of the projector goes beyond the control limit. Refer to measure 3.

Refer to measure 4 below if the life span of the lamp is running out or a problem with the lamp is detected.

Clearing Indicator Problems

Classification	State	Measures
Measure 1	When the cooling fan system is	Unplug and plug the cord and restart the projector. If the
	not in normal operating condition.	problem does not disappear, contact a dealer or service
		personnel near you.
Measure 2	When the lamp cover protecting	Check the screw on the bottom side of the projector. If you
	the lamp unit is not properly	do not find any problem, contact a dealer or service
	closed or the sensor system is not	personnel near you.
	in normal operating condition.
Measure 3	When temperature inside of the	Adjust the position of the projector following the
	projector becomes too high.	installation instructions of this manual and cool off the
		projector before restarting it. If the problem does not
		disappear, contact a dealer or service personnel near you.
Measure 4	The lamp is malfunctioning after	Power off the projector and cool it off for some time before
	abnormal power off or restarting	restarting it.
	right after turning off the projector.
	When brightness of the picture	Check how long the lamp has been used on Information
	screen degrades or image	and contact a dealer or service personnel near you for lamp
	deterioration is found.	replacement.

	This Projector uses a cooling fan system to keep the unit from overheating.
NOTE	Operation of the cooling fan may cause noise, which does not affect the product performance.
	No exchange or refund for the noise concern.

Preparation

Accessories and Projector

9