setting up your
Remove any residual matter inside the purifier. (Model with the purifier)
PU
-Open the main water tap to check whether water is running through the water tube on the water inlet side of the purifier.
-If water does not come out through the line, check whether the tap is open.
-Leave the tap open until clean water is running out and any residual matter that built up during manufacturing has been removed.
OUTLET SIDE | PURIFIER |
OF PURIFIER | |
WATER | WATER LINE |
|
01SETTING
Attach the purifier lock stations.
-Hold the purifier lock stations in the appropriate position (under the sink for example) and fix it tightly into place where to screw.
TWO PURIFIER LOCK STATION
TWO PURIFIER LOCK STATION
Secure the purifier in position. | WATER TUBE |
-Fix the purifier in position, as shown in the figure on the right.
PURIFIER | PURIFIER | |
LOCK | ||
| ||
TIGHTENING | STATIONS | |
| ||
BAND |
|
Connect the water line to the refrigerator.
- Remove the compressor cover of the refrigerator.
- Connect the water line to the valve, as shown in the figure.
- When connected, check if there is any leakage. If any, repeat the connection.
- Reattach the compressor cover of the refrigerator.
WATER LINE
CONNECTION NUT
INSTRUCTIONS COMPRESSOR COVER OF REFRIGERATOR
Secure the water line.
- Using clip ”A”, fix the water line to the wall (the back of | CLIP A |
refrigerator). |
|
- When the water line is secure, make sure whether the water line |
|
is not excessively bent, pinched or squashed. | WATER LINE |
setting up _21