Samsung SSC-17TQ installation manual Installing the PIR Camera SMM-PIRCAM

e-16

4) INSTALLING THE PIR CAMERA (SMM-PIRCAM)

1.Choose an installation site that can sufficiently support 5 times the weight of the equipments to be installed.

2.Remove the screw (BH M2.6) at the bottom of the main unit by turning it counterclockwise, and then lift the assy-case front as you push it upward to detach it from the case-rear.

(❊ Do not apply excessive force, as doing so may damage the inside assembly.❊)

Assy-case front

Screw (BH M2.6)

CASE-REAR

3.Place the case-rear over the installation site and mark screw holes with a pencil (indicated by the circles in the illustration). Drill a pilot hole for each pencil mark (5mm in diameter and at least 35mm in depth), and then fully insert the supplied plastic anchors (HUD 5) into them.

4.Connect the Camera connector(RJ-11) cable to the case-rear as well as the cable to be connected to the terminal.

e-17

5.Align the two holes of the case-rear to the holes of the plastic anchors, and then fasten the screw- tappings (BH M3 X 30).

SCREW-TAPPING

G(BH M3 x 30)

SCREW-TAPPING

G(BH M3 x 30)