M a i n t e n a n c e
Familiarize yourself with these home maintenance tasks as proper use and care of your cleaner will ensure continued cleaning effectiveness.
When to empty the Dirt Cup
The dirt cup needs to be emptied when the dirt reaches the "Full" line on the side of the Cup. If more dirt than this accumulates, your cleaner will not operate effectively.
Note: All new carpet has loose fibers which can fill the Dirt Cup quickly while vacuuming.
Emptying the Dirt Cup
Disconnect cleaner from electrical outlet.
Full Line | |
Unlock | Lock |
Position | Position |
Slide the
Grasp handle and pull the Dirt Cup straight out to remove from Vacuum.
Empty dirt into garbage container. Put the Dirt Cup back in the vacuum and slide the lever to the "Lock" position.
Cleaning The Circular Filters.
Grasp the Filter Cup located at
the bottom of the Dirt Cup and twist counterclockwise to unlock and remove.
Cleaning the Pre/Post-motor Filter
Filter |
How to clean
Disconnect cleaner from electrical outlet.
The
It is located underneath the Dirt Cup and Filter Cup in the Center of the round part of the
Remove the small round Filter and any debris on top of it. Rinse
well under warm water, then air dry thoroughly before replacing.
The
When the filter becomes dirty, The
Open the door, remove the filter and replace.
The
Replace the door by inserting the tabs on the left side and snapping the right side into place.
Grasp the Circular Filters and twist to unlock.
Pull straight up to remove. Separate the Outer foam and Inner pleated Circular Filters. Wash each individually by hand in warm water. Mild detergent may be used if desired.
Rinse well, then air dry Thoroughly dry before putting them back together and replacing in the Filter Cup The Filter Cup may be washed In warm water with a mild detergent. Make sure it is completely dry before reassembling with fliters.
Do not operate cleaner without Either the
5
