Samsung SU-2950 Series The belt, When to replace, How to replace, 3-12, M a i n t e n a n c e

Models: SU-2950 Series

1 12
Download 12 pages 15.14 Kb
Page 7
Image 7
M a i n t e n a n c e

 

M a i n t e n a n c e

 

The belt

3-7

3-8

The belt on your cleaner causes the

 

 

agitator to rotate and is important for

 

 

the effective operation of the

 

 

cleaner. The belt is located under

 

 

the bottom plate of the cleaner and

 

 

should be checked from time to time

 

 

to be sure it is in good condition.

 

 

When to replace

 

 

Disconnect cleaner from electrical outlet.

To check belt, remove bottom plate as shown in “How to replace.” Replace belt if it is stretched, cut or broken.

How to replace

Disconnect cleaner from electrical outlet.

Place handle in low position and turn cleaner over so bottom side is up. Remove the 5 screws as shown with a screw driver.

Remove agitator and used belt. Discard used belt.

3-9

With lettering on outside of belt and positioned as shown in box on (D), slide new belt over motor pulley (B).

3-10

Insert agitator through belt and place belt in belt guide (C) on agitator.

Should the agitator shield (D) become dislodged while replacing the belt or the agitator, reposition it as shown, noting the placement of its belt guide (E)

3-11

Grasp agitator firmly and fit it into position by first sliding the end opposite the belt into the rectangular slot (F) on side of cleaner.

Pull other side of agitator (G) into place. Turn agitator, making sure belt is not pinched between agitator and agitator shield.

3-12

Reposition bottom plate and 5 screws. Tighten screws securely.

When to replace the agitator brush roll

When agitator brushes are worn, the agitator should be replaced.

To check condition of brushes, disconnect cleaner from electrical outlet.

Move the edge of a card across bottom plate while turning agitator. To maintain cleaning effectiveness, replace agitator if brushes do not touch card.

3-13

How to replace

Disconnect cleaner from electrical outlet.

Remove bottom plate, belt and agitator following directions in “The belt” section beginning with Fig. 3-10.

Discard old agitator.

Continue following the directions in “The belt” section to reposition belt, new agitator and bottom plate.

6

Page 7
Image 7
Samsung SU-2950 Series The belt, When to replace, How to replace, 3-12, M a i n t e n a n c e, 3-10, 3-11, 3-13