System Requirements, Installing the CD-R/RW Drive, English

System Requirements

Before you install the CD-R/RW drive, we strongly recommend that you make certain that your set-up meets the system requirements listed below.

Item	Description
Type of computer	Pentium 133MHz(or higher) with an IDE interface
	(For 6X writing, 166MHz recommended)

RAM	16MB RAM(or higher) (Recommend 32MB)
Hard drive	528MB higher(Transfer Rate 800KB/sec higher, Access
	Time 20msec Lower)
MS-DOS	5.0(or higher)
	TIP:For MS-DOS, The CD-R/RW drive can only Read a
	disc without Premaster Software
Windows	Microsoft® Windows 95®, 98® or Windows NT 4.0®
	TIP:For Windows NT®, we recommend Service Pack3.

Install the CD-R/RW drive in your computer horizontally, making sure that the Open/Close button is on the right.

1 Turn OFF your computer. Remember to verify the configuration jumper on the rear of the CD-R/RW drive.

2 Remove the cover of your PC(main unit of the computer).

3 Remove the blank cover panel of the 5.25 inch unit in which the CD-R/RW drive is to be installed.

4 Connect the CD-R/RW drive to the IDE interface and power cables located inside your computer.

☛Connectors are keyed so it is impossible to put them in

☛an incorrect position. Do not force the connectors, if they

☛ do not seem to fit.

5 Install the CD-R/RW drive into the unit and secure it with mounting screws (recommended standard M3x6).

☛◆Depending on your PC model, you may need to attach

☛◆guide rails to the drive, so that the drive is held firmly in place.

☛◆On the ground that the guide rails are parts of the computer,

☛ ◆if you don’t have these, please purchase separately.

☛◆ If you use screws that are longer than the recommended

☛ ◆standard, you may damage the drive.

6 Put the cover back on your PC.

You can install the device driver for DOS or for Windows.
TIP : You can use the CD-R/RW drive to only read a disc in DOS/Windows 3.1.
*	Device Driver is located at [DDriver] folder of bundle [Recording S/W CD]

1		Turn on your computer and wait for it to boot.		English
2		Insert the bundle CD into CD-R/RW driver.
3		Windows 95/98 user	◆ When you are in Windows 95/98 or NT,
3		/NT 4.0	it is not necessary to install Device
			Driver. Whereas, when you are in Dos
			Mode of Windows 95/98 or NT,
			then install as follows.
			◆ Click on MY COMPUTER icon.
			◆ Click on the CD-R/RWicon.

4		Run the CDSETUP program:
		Windows user	Double-click CDSETUP.EXE of
			[DDRIVER] folder from the Windows File
			Manager.

5		To...	Then click...
		Confirm the installation	OK

		Exit without installing	CANCEL

		Result: If you answer Y(OK), the installation program automatically
		◆ Creates a SAMSUNG directory on your hard disk
		◆ Copies the required softwares (mscdex.exe and sscdrom.sys)
		◆ Modifies the CONFIG.SYS and AUTOEXEC.BAT files

6		When the Setup Completed screen is displayed, remove the installation
		disk from the drive.
7		Reboot your system.
		Result: ◆ The computer restarts
		◆ Both the device driver and MSCDEX are loaded.