Assembling the rat protection panel(option)

Tilt the washer a little and lift up the panel until it clicks, finally fix the panel with screw to the base as shown in the figure.

Rear-side

1.Insert the rat protection panel to the assembling hole on back side to the end.

2.If you have difficulty inserting the panel lift up the washer a little and insert it.

How to connect the drain hose(option)IN CASE OF PUMP-DRAINED WASHER

Take out the cap-hose and connect the outlet-hose.

cap-hose

Be sure to join tightly the drain hose into the drainoutlet on the back of the machine.

Be sure to join tightly the drain hose into the drain-outlet on the side of the machine.

Install the drain hose in the position of about 90~100cm above the ground.

90~100cm

CONNECTING THE DRAIN HOSE

(a)

After pressing the joint ring(a), insert the drain hose(b) to drain

direction.

 

Test run

(b)

Make sure that you install your washing machine correctly by running the Rinse+Spin cycle after the installation is complete.

How to put the detergent in

1.Open the detergent box by pulling in the direction of the arrow as shown in the figure and then put the powder detergent in the detergent box.

2.Put in one-time amount of detergent evenly so the detergent may not brim over the box.

If you spread a powder detergent over the laundry directly, it may result in discoloration. Make sure to insert it into the detergent compartment.

CAUTION

installation & maintenance_11

WA50G5DFP-02898N_EN_20121220.indd 11

 

 

2012-12-20 �� 3:41:58