INSTALLATION

ENVIRONMENT

Leave some space

Space at last 15cm between the washer and the wall.

Place the washer on a sturdy flat surface.

If the washer is placed on an uneven or weak surface, noise or vibration may be occured. (Allowable is 2˚)

CHANGING THE POSITION OF THE DRAIN HOSE

Before attempting to change the position of the drain hose, disconnect the plug from the outlet.

1. Route the drain hose inside the machine.

2.Take out the drain hose from the opposite hole and insert the drain hose into the hose holder.

LAUNDRY GUIDE

AMOUNT OF CLOTHES

Water Level

Low

Middle

High

 

 

 

 

Shirts(Synthetics)

22 Pieces

29 Pieces

35 Pieces

 

 

 

 

Under Shirts(Cotton)

38 Pieces

48 Pieces

58 Pieces

 

 

 

 

Working clothes(Cotton)

16 Pieces

20 Pieces

25 Pieces

 

 

 

 

Never install the washer near water.

Do not place the washer in steamy rooms or where the washer is directly exposed to rain. Moisture may destroy the electrical insulation and cause an electrical shock hazard.

Avoid direct sunlight or heating devices.

As plastic and electrical components are

2

1

Hose holder

DETERGENT

AMOUNT OF

WATER

DETERGENT

LEVEL

44g

Low(44l)

 

 

56g

Middle(56l)

 

 

67g

High(67l)

 

 

SPIN DRY TIME

TIME

TYPE OF LAUNDRY

1min.

Thin(synthetic fiber)

1~2min.

wool

3~5min.

cotton

5min.

thick(cotton)

affected by direct heat, never place the washer near heaters, boilers,etc.

Do not place under direct sunlight.

Install the drain hose about 70~80cm above the ground

for pump model.

70~80cm

 

HOW TO CLEAN THE FILTER (In case drain pump)

1.Place a rag under the washer filter not to wet the floor.

2.Rotate the filter counterclockwise and pull out the filter.

3. Remove dirts and rotate

 

Filter

the filter clockwise until it

 

 

locks in position.

Open

Close

 

 

Rag

-The amount of detergent is average.

Follow the instruction detergent printed on the package for amount of detergent.

-Choose the amount of detergent depending on the fabric type.

 

MAINTENANCE

WHEN YOU LOAD THE LAUNDRY INTO

TO PICK OUT THE CLOTHING WHICH HAS

THE SPIN BASKET.

FALLEN BETWEEN THE BASKET AND TUB.

Press the laundry evenly and put the safety

For safty, pull the power supply plug out of the socket.

cover into the spin basket drum as shown in

1.Disassemble two screws from the spin dryer hatch.

the figure.

2.Pull up the spin dryer hatch to remove it.

 

3.Remove the clothing.

 

4.Close the spin dryer hatch.

CLEANING THE MACHINE

1. OVERFLOW FILTER

Pull the upper side of the overflow filter with

your fingers into the holes in the direction of arrow as shown in the figure.

3. CLEANING THE WASHER BODY

2. CLEANING THE FILTER

Pull the overflow filter out and take up the filter by removing 3 screws as shown in figure. Wash the filter and washing tub.

TROUBLE SHOOTING

TROUBLE

CHECK POINT

TROUBLE

CHECK POINT

 

 

 

 

 

 

 

Is the filter clogged

The washer

Check that the power cord is

Incomplete

with lint?

does not work.

connected to a power outlet well.

draining

● See “Cleaning the

 

Power stoppage?

 

machine” on page 7.

 

 

 

 

 

 

 

Is the spin dryer lid closed

Wipe off strains on the cabinet and operation panel with soft cloth.

Do not use benzene,thinners,cleanser,or wax, nor scrub the washer with a brush. Painted surfaces or plastic parts will be damaged.

Clothes will

 

 

completely?

not move freely. Is the laundry overloaded?

The spin dryer

Are laundry(socks,etc.)falling

 

 

basket will not out of the spin dryer basket and

 

 

run.

clinging to the axle?

Incomplete

 

Are the laundry arranged evenly?

 

● See “To pick out...” on

spinning

 

page 8.

 

 

7

8