20
OPERATION
Memorizing the Channels

Your TV can memorize and store all of the available channels for both “off-air” (antenna)

and cable channels. After the available channels are memorized, use the CH and

CH buttons to scan through the channels. This eliminates the need to change

channels by entering the channel digits. There are three steps for memorizing channels:

selecting a broadcast source, memorizing the channels (automatic) and adding and delet-

ing channels (manual).

Selecting the Video Signal-source

Before your television can begin memorizing the available channels, you must specify the

type of signal source that is connected to the TV (i.e., an antenna or a cable system).

1
Press the MENUbutton to
display the menu.
Press the ▲ or ▼button
to select “Channel”, then
press the ˇor ˆbutton.
2
Repeatedly press the ˇor
ˆbutton to cycle through
these choices:
ANT (antenna), STD, HRC
or IRC (all cable TV).
Press the EXITbutton to
exit.

Note: STD, HRC and IRC identify various types of cable TV systems. Contact your local cable com-

pany to identify the type of cable system that exists in your particular area.

At this point the signal source has been selected. Proceed to “Storing Channels in Memory” (next

page).

ANT/CATV ˇˇ
ANT ˆˆ
Auto Program ˆˆ
TV/AV ˇˇ
TV ˆˆ
Fine Tune ˆˆ
Add/Erase ˆˆ
Channel
Move Select Exit
ANT/CATV ˇˇ
ANT ˆˆ
Auto Program ˆˆ
TV/AV ˇˇ
TV ˆˆ
Fine Tune ˆˆ
Add/Erase ˆˆ
Channel
Move Select Exit