Samsung TXM 3297HF, TXM 2796HF, TXM 3098WHF, TXM 2798HF, TXM 3296HF manual Example Antenna Grounding

•Protect the power cord. Power supply cords should be routed so that they won’t be walked on or pinched by objects placed on or against them. Pay particular attention to cords at plugs, convenience receptacles, and the point where they exit from the unit.

•Unplug the TV from the wall outlet and disconnect the antenna or cable system during a lightning storm or when left unattended and unused for long periods of time. This will pre- vent damage to the unit due to lightning and power-line surges.

•Avoid overhead power lines. An outside antenna system should not be placed in the vicinity of overhead power lines or other electric light or power circuits or where it can fall into such power lines or circuits. When installing an outside antenna system, be extremely careful to keep from touching the power lines or circuits. Contact with such lines can be fatal.

•Do not overload the wall outlet or extension cords. Overloading can result in fire or electric shock.

•Do not insert anything through the openings in the unit, where they can touch dangerous voltage points or damage parts. Never spill liquid of any kind on the TV.

•Ground outdoor antennas. If an outside antenna or cable system is connected to the TV, be sure the antenna or cable system is grounded so as to provide some protection against voltage surges and built-up static charges. Section 810 of the National Electrical Code, ANSI/NFPA No.70-1984, provides information about proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna discharge unit, connection to grounding electrodes, and requirements for the grounding elec- trode.

EXAMPLE OF
ANTENNA GROUNDING	ANTENNA
	LEAD IN WIRE
GROUND CLAMP
	ANTENNA
	DISCHARGE UNIT
ELECTRIC	(NEC SECTION 810-20)
SERVICE	GROUNDING
EQUIPMENT
	CONDUCTORS
	(NEC SECTION 810-21)
	GROUND CLAMPS
	POWER SERVICE GROUNDING
	ELECTRODE SYSTEM
NEC — NATIONAL ELECTRICAL CODE (NEC ART 250, PART H)

2SAFETY

•Do not attempt to service the TV yourself. Refer all servicing to qualified service personnel. Unplug the unit from the wall outlet and refer servicing to qualified service personnel under the following conditions:

-when the power-supply cord or plug is damaged

-if liquid has been spilled on the unit or if objects have fallen into the unit

-if the TV has been exposed to rain or water

-if the TV does not operate normally by following the operating instructions

-if the TV has been dropped or the cabinet has been damaged

-when the TV exhibits a distinct change in performance

•If you make adjustments yourself, adjust only those controls that are covered by the operat- ing instructions. Adjusting other controls may result in damage and will often require exten- sive work by a qualified technician to restore the TV to normal.

•When replacement parts are required, be sure the service technician uses replacement parts specified by the manufacturer or those that have the same characteristics as the original part. Unauthorized substitutions may result in additional damage to the unit.

•Upon completion of any service or repairs to this TV, ask the service technician to perform safety checks to determine that the TV is in a safe operating condition.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1)This device may not cause harmful interference, and

(2)This device must accept any interference that may cause undesired operation.

This television receiver provides display of television closed captioning in accordance with §15.119 of the FCC rules.