troubleshooting
PROBLEM | SOLUTION | |
|
| |
Motor dows not start. | • Check cable, pulg and socket. | |
• Leave to cool. | ||
| ||
|
| |
Suction force is gradually | • Check for blockage and remove. | |
decreasing. | ||
| ||
|
| |
Cord does not rewind fully. | • Pull the cord out | |
rewind button. | ||
| ||
|
| |
Vacuum cleaner dows not pick | • Check hose and replace if required. | |
up dirt. | ||
| ||
|
| |
| • Please check filter and, if required, clean as | |
Low or decreasing suction | illustrated in the instructions. if filters are out of | |
| condition change them to new ones. | |
Body overheating | • Please check filters, If required clean as | |
illustrated in the instruction. | ||
| ||
|
| |
Static electicity discharge | • Please decrease power suction. | |
|
|
Thermal protector : This vacuum cleaner has a special thermostat that protects the motor in case of its overheating. If the vacuum cleaner suddenly shuts off, turn off the switch and unplug the vacuum cleaner. Make sure that there is power in the socket. To avoid electric shock, please contact a qualified electrician. Check the vacuum cleaner for possible source of overheating such as a full dust tank, a blocked hose, pipe, or clogged filter. If these conditions are found, fix them and wait at least 30 minutes before attempting to use the vacuum cleaner. After the 30 minute period, plug the vacuum cleaner back in and turn on the switch.
If the vacuum cleaner still does not run, contact a service engineer.
This Vacuum cleaner is approved the following.
EMC Directive : 2004/108/EEC
Low Voltage Directive : 2006/95/EC
14_ troubleshooting
2017. 6. 21. |
| �� 5:18 | |
|