Troubleshooting
PROBLEM | SOLUTION | ||
|
| ||
Motor downs and does | • Check cable, plug and socket. | ||
not start. | • | Leave to cool. | |
Suction force is gradually | • Check for blockage and remove. | ||
decreasing. | |||
|
| ||
Cord does not rewind | • Pull the cord out 2~3m and push down the cord rewind | ||
fully. |
| button. | |
Vacuum cleaner downs, | • Check hose and replace if required. | ||
does not pick up dirt | |||
|
| ||
Water leakage from the | • Check rubber packing inserted tightly at the upper part. | ||
dust bin. | |||
|
| ||
Excessive water drops | • Some droplets on the inside body are to be expected. | ||
from the inside of the | |||
| Please dry the aqua cyclone fully. | ||
body. |
| ||
|
| ||
Dirty water comes out | • | Check the filter is located properly. | |
of the top of the main | • If the amount of water becomes excessive, check if water | ||
body |
| inside dust bin is over the max line and make the water level | |
|
| is under the max line. | |
Water comes out from | • Check the water level of the aqua cyclone. | ||
the back cover. | • Please operate the vacuum cleaner without the aqua | ||
|
| cyclone until water does not come out from the back cover. | |
Low or decreasing | • Please check filters. If required clean it as illustrated in the | ||
suction. |
| instruction. If filters are out of conditions, change them to | |
|
| new one. | |
Body overheating | • Please check filters. If required clean it as illustrated in the | ||
|
| instruction. | |
Static electricity | • Please decrease power suction. | ||
discharge | • Please ventilate room to increase humidity. | ||
Unpleasant smell during | • Please note that there may be a slight smell during | ||
vacuuming |
| vacuuming when the cleaner is new | |
Nozzle does not spray | • Clean the nozzle hole with a slender tool. | ||
water well. | |||
|
| ||
Water supply from the | • | Check and clean the water filter of the water supply hole. | |
water tank is uneven. | |||
|
|
T 04roubleshooting