installing your washer
Connecting the drain hose
The end of the drain hose can be positioned in three ways:
Over the edge of a wash basin
Secure the guide to the side of the basin wall with a hook or to the tap with a piece of string to prevent the drain hose from moving.
In a standPipe or laundry tub
The standPipe must be no shorter than 39 in (99 cm) and no longer than 96 in (245 cm).
Make sure that the connection between the drain hose and the standPipe is not airtight.
Laundry tub | Stand Pipe | ||
Hose |
|
|
|
retainer |
|
|
|
96” Max |
|
| 39” Min |
39” Min |
|
| |
Tie |
|
| (99 cm) |
strap |
|
|
|
STEP 3
Leveling your washer
See if the washer is level by checking the position of the tub:
1.Slide the washer into position.
2.Open the lid of the washer, and pour the water into the tub to just below the pulsator level.
3.If the washer is level, the pulsator is positioned at the center of the water as shown in the figure. If not, level your washer by turning the front leveling feet clockwise or counterclockwise as necessary.
Turn the front leveling feet clockwise to raise the washer, and counterclockwise to lower the washer.
Pulsator
Loosen Lock Adjustable legs
16_ installing your washer
2015/7/30 9:27:46