Samsung WA50F9A6DSW Temperature of the water, Cause mold, Or Sanitize Cycle or Pure Cycle

Models: WA50F9A6DSW

1 132
Download 132 pages 57.93 Kb
Page 32
Image 32

troubleshooting

PROBLEM

SOLUTION

 

 

 

fills with the wrong

Turn both faucets on fully.

temperature water.

Make sure the temperature selection is correct.

 

Make sure the hoses are connected to the correct faucets.

 

 

Flush water lines.

 

Disconnect the hoses and clean the screens. The hose filter screens

 

 

may be plugged.

 

As your washer is filling, the water temperature may change as

 

 

the automatic temperature control feature checks incoming water

 

 

temperature. This is normal.

 

While your washer is filling, you may notice just hot and/or just

 

 

cold water going through the dispenser when you have selected

 

 

cold or warm wash temperatures. This is a normal function of the

 

 

automatic temperature control feature as your washer determines the

 

 

temperature of the water.

 

 

 

Lid locked or will not open.

Press the Start/Pause button to stop your washer.

It may take a few moments for the lid lock mechanism to disengage.

does not drain and/or spin. Check the fuse or reset the circuit breaker.

Straighten the drain hoses. Eliminate kinked hoses. If there is a drain restriction, call for service.

Close the lid and press the Start/Pause button. For your safety, your washer will not spin unless the lid is closed.

load is too wet at the end

Use the High spin speed.

of the cycle.

Use high efficiency

detergent to reduce over–sudsing.

 

The Load is too small. Very small loads (one or two items) may

 

 

become unbalanced and not spin out completely.

 

 

 

leaks water.

Make sure all hose connections are tight.

 

Make sure the end of the drain hose is correctly inserted and secured

 

 

to the drainage system.

 

Avoid overloading.

 

 

Use high efficiency

detergent to prevent over–sudsing.

 

 

 

 

has excessive suds.

Use high efficiency

detergent to prevent over-sudsing.

 

Reduce the detergent amount for soft water, small or lightly soiled

 

 

loads.

 

 

Non-HE detergent is NOT recommended.

 

 

 

Has an odor.

Check your Detergent . Excessive suds collect in nooks and crannies

 

 

and cause mold.

 

 

• Run cleansing cycles to sanitize the machine periodically.(Silver Care

 

 

or Sanitize Cycle or Pure Cycle)

 

• Dry the interior of your washer after the total cycle has finished.

32_ troubleshooting

F900A WASH_WA50F_USER MANUAL_DC68-03133H_EN.indd 32

2013-1-23 16:48:52

Page 32
Image 32
Samsung WA50F9A6DSW user manual Temperature of the water, Cause mold, Or Sanitize Cycle or Pure Cycle