Adjustment the Height of the Machine

Adjust the legs to level the washer

Be careful not to put in your hand under the legs.

Pull the handles located at the right and left of the front side and slide off.

Adjust the height of the machine upward or downward.

When the adjustment is finished, push the handles to fix the adjusting legs.

Waterdrop Cause	How to level
mark
The front part is	Level it by adjustable legs.
lower
The back part is	Adjust the height by using the adjustable
lower	rubber or prop at the back.
The left part is	Adjust the left part by using the adjustable
lower	legs at the front and the adjustable rubber
	at the back.
The right part is	Adjust the right part of the washer by
lower	using the adjustable leg at the front and
	the adjustable rubber at the back.

■CONNECTING THE WATER SUPPLY HOSE

1. Remove the adaptor from the water supply hose.

2.	First, using a “+” type screw driver, loosen the four
	screws on the adaptor. Next, take the adaptor and turn
	part(b) following the arrow for gap about 5mm between
	them.
3.	Connect adaptor to the water tap by tightening the
	screws firmly. Then, turn part(b) following the arrow and
	put (a) and (b) together.	a
	put (a) and (b) together.	b
		b
4.	Connect the water supply hose to the adaptor. Pull down
	the part (c) of the water supply hose. When the part (c) is
	released, the hose is automatically connected to the	c
	adaptor making a ‘click’ sound.	c
	adaptor making a ‘click’ sound.
5.	Connect the other end of the water supply hose to
	the inlet water valve at the back of the washer.
	Screw the hose clockwise all the way in.

5-1. Connect the other end of the water supply hose to the inlet water valve at the top of the washer.

Screw the hose clockwise all the way in.

☞ If the water tap is a screw type, assemble a water supply hose that fits to the tap as shown.

After completing connection, if water leaks from the hose, then repeat the same steps.

Use the most conventional type of faucet for water supply.

In case the faucet is square or too big, remove the spacing ring before inserting the faucet into the adaptor.

- 10 -