052

Command Lever

You can enable the desired features for

the command lever on the back of the

camera.

- [Command Lever] Sub menus:
[EV], [EV(A, S)], [ISO], [WB]
- Move the command lever to the left
or right to select the submenu for each
feature.
For detailed information on using the command lever, refer to Page 31.
The [Command Lever] feature is enabled in [Program], [Manual],
[DUAL IS], or [Movie] mode.
Selectable sub-menu and default value can vary depending on
recording mode.
Flash Intensity

You can control fl ash intensity.

(You can set fl ash intensity within the

range of +/- 1EV in intervals of 0.5EV.)

- [Flash EVC] Sub menus:
[+1.0], [+0.5], [0], [-0.5], [-1.0]
In [Auto], [DUAL IS], [Beauty Shot], [Smart Auto], [Scene], or
[Movie] mode, the [Flash EVC] feature is disabled.
If the subject is too close or the sensitivity is too high, changing
the value to a negative value (-) may not have any effect.
If the fl ash intensity is out of the control range because the
exposure value is too high or low, the camera may not operate
properly.
RECORDING
Command Lever
Flash EVC
Quality
ACB
OIS
Voice Memo
Back Set
OK
+1.0
+0.5
0
-0.5
-1.0
RECORDING
Command Lever
Flash EVC
Quality
ACB
OIS
Voice Memo
Back Set
EV
ISO
WB
2008/12/01 PM 01:00
2008/12/01 PM 01:00
1
1