Problem |
| Action | |
|
| ||
| • Fully open both taps. | ||
| • Make sure the temperature selection is correct. | ||
| • Make sure the hoses are connected to the correct taps. Flush | ||
|
| water lines. | |
| • Make sure the water heater is set to supply a minimum | ||
|
| 120 °F (49 °C) hot water at the tap. Also, check the water | |
|
| heater capacity and recovery rate. | |
| • Disconnect the hoses and clean the mesh filter. The mesh filter | ||
Fills with the wrong |
| may be clogged. | |
water temperature. | • | While the washing machine fills, the water temperature may | |
|
| change as the automatic temperature control feature checks | |
|
| incoming water temperature. This is normal. | |
| • While the washing machine fills, you may notice just hot and/ | ||
|
| or just cold water going through the dispenser when cold or | |
|
| warm temperatures are selected. | |
|
| This is a normal function of the automatic temperature | |
|
| control feature as the washing machine determines the water | |
|
| temperature. | |
|
| ||
| • Use the High or Extra High spin speed. | ||
Load is wet at the | • Use high efficiency (HE) detergent to reduce oversudsing. | ||
• | Load is too small. Small loads (one or two items) may become | ||
end of a cycle. | |||
| unbalanced and not spin completely. | ||
|
| ||
| • Make sure the drain hose is not kinked or clogged. | ||
|
| ||
| • Make sure the door is properly closed. | ||
| • Make sure all hose connections are tight. | ||
Leaks water. | • Make sure the end of the drain hose is correctly inserted and | ||
| secured to the drain system. | ||
|
| ||
| • | Avoid overloading. | |
| • Use high efficiency (HE) detergent to prevent oversudsing. | ||
|
| ||
| • Excessive suds collect in recesses and can cause foul odours. | ||
Has odours. | • Run cleansing cycles to sanitize periodically. | ||
• | Clean the door seal (diaphragm). | ||
| |||
| • Dry the washing machine interior after a cycle has finished. | ||
|
|
| |
No bubbles are seen | • | Overloading may screen bubbles. | |
(Bubbleshot models | |||
• | Severely contaminated laundry may not generate bubbles. | ||
only). | |||
|
| ||
|
|
| |
If a problem persists, contact a local Samsung service centre.
English 51
Troubleshooting
|
| 2017/2/16 18:53:28 | |
|
| ||
|
|
|
|