useful tips for your drum washing machine
Cleaning the debris ﬁlter
✔When water does not drain well or ‘5E’ blinks on the display, clean the debris ﬁlter. The product appearance may differ from your washing machine. (However, the cleaning descriptions are the same.)
✔The descriptions and images in this document may differ from your actual purchased product. For more information, refer to the user manual.
INSTALLING YOUR WASHING MACHINE
1. Open the ﬁlter
cover using a coin
or a key.
4. Unscrew the emergency drain cap by turning it counter clockwise.
•Installing your washing machine in the location which is slippery
or uneven, will result in vibrations and noise.
• If there is too much noise or vibration, check whether the four levelling adjustment legs are evenly and ﬁrmly on the ﬂoor.
•If the washing machine is not level, lift the washing machine
slightly and adjust the lowest of the four levelling adjustment legs.
✔ Before using your washing machine, you must remove the shipping bolts from the back of the unit.
For more information on removing the safety devices, refer to the user manual.
Make sure that the leveling feet legs are level with the ﬂoor.
cap and pull out the
tube to drain off the
Hold the cap on
the end of the
5. Clean the debris ﬁlter and the inside of the drain hose.
6. Replace the debris ﬁlter, the emergency drain
LEVELLING YOUR WASHING MACHINE WITH THE LEVELLING FEET
✔Refer to the descriptions appropriate to your washing machine.
tube and allow all
the water to ﬂow
into a bowl.
cap and tube and then close the ﬁlter cover.
Adjustable nut Spanner
1.Level your washer by turning the adjustable nut in and out, as shown in the ﬁgure.
2.When your washing machine is level, tighten the locking nut using the
✔If you open the debris ﬁlter when water remains inside the tub, water may ﬂow out.
✔If the debris ﬁlter is assembled incorrectly or not installed, it may cause a water leakage or operating error. Therefore make sure to assemble it correctly.
MAKE SURE YOU KNOW...
Adjustable feet Spanner
1.Unfasten the locking nut by turning it to the left using a spanner.
2.Level your washing machine by turning the adjustable feet in and out as necessary by hand.
3.Fasten the locking nut by turning it to the right using a spanner.
➲ Press the Add laundry(Stop&Add) button and add the laundry when the Add
laundry lamp turns on.
If you add the laundry during a spin cycle, it starts again with the initial set time
regardless of the remaining time.
• Wash bedding using only the Bedding course.
➲ You can wash acrylic, mixed spinning and woolen bedding.
CLEANING THE FILTER
Cleaning the water supply ﬁlter
✔If the ﬁlter net is not installed, it may cause a water leakage and operating error. Make sure to install it.
1. Pull and remove the ﬁlter net.
2. Clean the ﬁlter.
3. Insert the ﬁlter net and fasten
its connector ﬁrmly.
➲ When washing general clothes, the washing machine may
not operate in the optimal status.
• Wash only one bedding item at a time regardless of size.
➲ Insert bedding rolled up into a ball.
The center of gravity is distributed evenly causing less
vibrations and noise.
✔Do not wash electric blankets or carpets.
✔When spinning blankets, cotton bedding, and woolen bedding, too much noise and vibrations may occur and the wash cannot be completed as spinning is not performed.