Setting Environment
Do not set it at place where is too cold and
Do not set at outdoor places.
may freeze.
Do not use as floorstanding appliance. | Please mount it to firm and reliable wall. |
² »Ò ª° ײ °Ó ÚÎ Þ· Ũ ËÅ ®µ ĵ Ø· ½
Installation
Installation must be made by installers of or designated by our company
Before installation, make sure water heater rear wires are fit firmly. Determine an installation location. Make four holes 12mm, 65 mm deep in the wall with an impact drill according to installating dimension. Insert fixexpansion hooks and expansion bolts in corresponding wall holes. Lift the water heater. Insert wall rack onto the hooks and bolts. Fit flat washers, rear wires and nuts in turn onto the bolts (see Figure 2). Tighten the nuts and check them firm. Install accessories such as safety valve, drain hose as shown in Figure 3. Use sealing compound to prevent water leakage.
To facilitate installation and removal, it is suggested a G 1/2" movable nut is fitted at appropriate locations on inlet and outlet pipes respectively. Find water supply location. Connect inlet pipe, outlet pipe and city water pipe respectively to the use point.
The hot water pipe shall not be too long to reduce the heat losses.
Please reserve some space in installation for the future maintenance.
| In case connecting water heater with water drain |
Do not install to places without sewer. | hose, connect the drain hose to the inlet of the |
|
Hot water outlet valve
| Hot |
| water |
| outlet |
| Cold water inlet |
Cold water | Shower head |
outlet valve | |
Mixing valve |
|
Safety valve
sewer to avoid polluting by splashing. |
The original pipeline of the water heater is an organic part of "Safe Care". Do not remove it by yourself. Otherwise we will not take responsibility for the injure and loss caused by the safety trouble occurred therefrom.
Description of the Symbols
Never do that
Be sure to act as per instructions
5
(Figure 2)(Figure 3) for reference in installation only
Connection and use of safety valve:
The safety valve should be connected to the cold water inlet pipe. Please check carefully if the direction is correct after installation. The correct direction of installation is that the arrowhead on the safety valve should point to the water heater.
Please connect the drain hose to the safety valve. Connect one end of the hose to the safety valve vent and the other end to the sewage drain. The hose can be cut short or extended as necessary. The hose shall be installed as inclined downward.(see to Figure 4)
6