TROUBLESHOOTING

TROUBLE

CHECK POINT

TROUBLE

 

 

CHECK POINT

 

 

 

 

 

In case no drain pump.

1. The washer

Check that the power cord is

4. Water dose not

 

- Be sure lay the drain hose down.

 

In case drain pump.

does not

connected to a power outlet

 

drain.

 

- Be sure remove the cap-hose from the

work.

well.Power stoppage?

 

 

 

drain hole.

 

 

 

 

 

 

 

 

 

 

See“Before using...”on page 1.

2. Clothes will

 

 

 

 

Is the spin dryer lid closed completely?

 

 

5. The spin dryer

 

Arelaundry(socks,etc.)fallingoutofthespin

not move

Is the laundry overloaded?

 

basket will not run.

 

dryerbasketandclingingtotheaxle?

freely.

 

 

 

 

 

 

 

See“To pick out...” on page 6.

 

 

 

 

 

 

 

 

 

 

In case no drain pump.

 

 

 

 

 

- Is the Cycle Selector set to drain?

 

 

 

 

 

- Is the drain hose clogged with scrap?

3. Incomplete

Are the laundry arranged

 

 

Hang up drain hose over the drain hose

spinning.

6. The water drains

 

hook. Half fill the wash tub with the

evenly?

 

(Severe

 

water and try for drain again. (Scrab will

See“When you load...” on

out immediately.

 

vibration or

 

be removed by water drain pressure.)

page 6.

 

 

unbalance.

 

 

In case drain pump.

 

 

 

 

 

 

 

 

 

- Is the drain hose hung about 70~80 cm

 

 

 

 

 

above the ground?

 

 

 

 

 

See“Connectingthedrain...” onpage3.

SPECIFICATION

 

 

 

 

 

 

 

 

 

 

MAX WASHING CAPACITY

 

 

 

7 kg

MAX SPIN CAPACITY

 

 

 

3.5 kg

DIMENSIONS (mm)

 

W820mm x D524mm x H1000mm

WATER PRESSURE

 

 

 

0.05~0.78 MPa

 

 

0.5 ~ 8.0 kg.f/cm2

 

 

 

 

WEIGHT

 

 

 

 

36 kg

 

 

 

 

 

EXTRACTION EFFICIENCY

 

 

50 %

STANDARD QUANTITY OF WATER

 

Low : 44 ℓ

 

Middle : 56 ℓ High : 67 ℓ

MOTOR MAX INPUT

 

 

 

550 W

WASHING POWER CONSUMPTION

 

 

 

350 W

SPINNING POWER CONSUMPTION

 

 

 

250 W

RATING TIME

 

 

Washing 1Hour

 

 

Spinning 15minutes

The energy label value is determined by the following program. <Operating Procedures>

1.Set the Wash Selector to Heavy, the Water Selector to Wash, the Cycle Selector to Wash/Rinse, and supply water at 48 ºC by mixing cold and hot water until the water level reaches the marked level M.

2.Set the Wash Timer to 15 minutes, and when the time has passed, set the Wash Timer to 15 minutes again, and when the time has passed, set the Wash Timer to 10 minutes so that washing is performed for 40 minutes in total.

3.After washing is completed, drain the water until the tub is empty. (Set the Cycle Selector to Drain.)

4.After draining the water, move half of the laundry into the spin tub and perform the spin cycle for 2 minutes. When the spin cycle is complete, move the rest of the laundry into the spin tub and perform the spin cycle for 2 minutes.

5.Place all the laundry into the wash tub, set the Wash Selector to Normal, the Water Selector to Wash, the Cycle Selector to Wash/Rinse, supply cold water until the water level reaches the marked level H, and then perform the rinse cycle for 1 minute. (Set the Wash Timer to 1 minute).

6.After rinsing is the completed, drain the water until the tub is empty. (Set the Cycle Selector to Drain).

7.After draining the water, move half of the laundry into the spin tub and perform the spin cycle for 5 minutes. When the spin cycle is complete, move the rest of the laundry into the spin tub and perform the spin cycle for 5 minutes.

Contact SAMSUNG WORLD WIDE

If you have any questions or comments relating to Samsung products, please contact the SAMSUNG customer care center. 800-SAMSUNG(726-7864), www.samsung.com

WT60J7WNC1-01942X-03_EN.indd 8

 

 

2013-05-23 �� 5:25:00