INSTALLATION
ENVIRONMENT
Leave some space
Space at last 15cm between the washer and the wall.
Place the washer on a sturdy flat surface.
If the washer is placed on an uneven or weak surface, noise or vibration may be occured. (Allowable is 2°)
The washing machine shall not be inserted at a humid place.
Do not place the washer in steamy rooms or where the washer is directly exposed to rain. Moisture may destroy the electrical insulation and cause an electrical shock hazard.
Avoid direct sunlight or heating devices.
As plastic and electrical components are affected by direct heat, never place the washer near heaters, boilers,etc. Do not place under direct sunlight.
CHANGING THE POSITION OF THE DRAIN HOSE Before attempting to change the position of the drain hose, disconnect the plug from the outlet.
1.Route the drain hose inside the machine.
2.Take out the drain hose from the opposite hole and insert the drain hose into the hose holder.
HOW TO CLEAN THE FILTER (In case drain pump)
1.Place a rag under the washer filter not to wet
the floor. | Filter |
2. Rotate the filter | Open Close |
counterclockwise and pull | |
out the filter. | Rag |
3.Remove dirts and rotate the filter clockwise until it locks in position.
Remark : Should be cleaned Filter at least 1 time a week.
CONNECTING THE DRAIN HOSE
Insert the drain hose(a) and push it tighly to be connected as arrow direction.
(WITHOUT
PUMP)
Install the drain hose(A) about 70~80cm above the ground for pump model.
CLEANING THE MACHINE
CLEANING THE LINT FILTER
If the dregs are filled up in the lint filter after finishing the wash, push down(1) and pull it out(2) as shown in figure.Remove the collected lint and rinse the filter net.
Lint Filter
CLEANING THE WASH TUB
Wipe off strains on the cabinet and operation panel with soft cloth. Do not use benzene, thinners, cleanser, or wax, nor scrub the washer with a brush. Painted surfaces or plastic parts will be damaged.
3
CLEANING THE COVER WINDOW SPIN
1.Rotate the cover window spin clockwise and pull out.
2.Cleaning the cover window spin.
3.Insert the cover window spin back and rotate it counterclockwise until locks in positon.
Remark : Should be cleaned the cover window spin at least 1 time a month.
Close 
Open
Cover Window Spin
5:24:57
