Connecting yepp to PC with USB cable
3 Plug one end of the USB cable into the USB port on the back of the PC.4 Connect the opposite end of the USB cable to the USB cable port on the bottom of the yepp.
●If you disconnect the USB cable from your PC while implementing a command or initializing during USB driver installation, your PC may not function correctly.
●The yepp will automatically turn on.
5 USB driver is installed with a message saying that it is searching for a new device. You may not see the display screen during installation.
Go to the device manager to check that installation has been successfully completed.
6 Upon installation of the USB driver "SAMSUNG
[System Properties] ➝ [Device Manager].
cable connect USB
Note :
HowHow toto checkcheck USBUSB driverdriver
Windows 98:
Control Panel ➝ System ➝ Device Manager ➝
Universal Serial Bus controllers/SCSI and RAID controllers Windows 2000:
Control Panel ➝ System ➝ Hardware ➝
Device Manager ➝ Universal Serial Bus controllers ➝
USB Mass Storage Device Windows XP:
Control Panel ➝ System ➝ Hardware ➝
Device Manager ➝ Universal Serial Bus controllers ➝
USB Mass Storage Device
7 When USB driver is not Installed automatically, refer to next page.Note :
For WinXP, the following window will appear whenever you connect the USB cable to your yepp.
14 | 15 |