10.Position end cap with flat sides of center hole over flat sides of threaded shaft (C).
11.Tighten locknut (B).
12.Align holes and secure rubber end cap cover flat side against end cap (A).
When properly assembled, the brush roll should rotate freely between the two end caps. Check the condition of the belt; change if necessary. Replace the brush roll, belt, and bottom plate (see How To Replace A Worn Belt).
Ask for GENUINE EUREKA replacement brush strip. 12 inch No. 52282; 16 inch No.
Brush Roll Belt
The brush roll belt on the upright vacuum cleaner drives the brush to agitate, sweep, and comb the carpet nap. The belt should be checked regularly to be sure it is in good condi- tion. Replace the belt if it is stretching, cracking, or slipping. Cut away any hair or thread wound around the brush roll or the belt pulley because the buildup could cause the belt to rotate unevenly.
How To Replace A Worn Belt
3.Place new belt around brush roll.
4.Align brush roll pulley with belt guide.
Belt
Guide
43
5.Place rubber end cap covers over both end caps (flat side against end cap). Align the holes and secure.
Then, slant brush roll forward so end caps are in line with slots in cleaner base.
6. Push brush roll into | 5 |
place.
6
CAUTION: Turn off the switch and unplug the electrical cord before replacing belt. Belt pulleys can become hot during normal use. To prevent burns, avoid touching the belt pulley when servicing the drive belt.
IMPORTANT: Improper installation of the brush roll or brush roll belt could cause carpet or cleaner damage.
11
7
8.Place slots of bottom plate over tabs of cleaner base.
9.Seat and secure cam locks.
7.Place lower side of belt into belt guide and pull to stretch the belt around the left side of motor pulley. Rotate pulley to secure belt into pulley groove.
99
1. Release cam locks and remove bottom plate.
2 Motor
Pulley
2.Pull up on belt to rotate it off the motor pulley. Lift up on brush roll and remove worn belt.
88
Ask for GENUINE EUREKA replacement belts, No. 52100
How To Change Furniture Guard
Four screws on the underside of the base secure the furniture guard.To gain access to the two rear screws, you must remove the four screws holding the two axle clamps and remove the rear wheel assembly. The front two screws are exposed by removing the soleplate and brush roll. Remove the four furniture guard screws, install the new guard and tighten the four screws. Reinstall the brush roll, soleplate and rear wheel assembly.
7
