Memorizing channels
This TV is equipped with a channel memory feature which allows channels to skip up or down to the next channel set into memory, skipping over unwanted channels. Before selecting channels, they must be programmed into the TV’s memory. To use this TV with an antenna, set the Signal Type option to the Air mode. When shipped from the factory, this menu option is in the Cable mode.
Air/Cable selection
1 Select “Channel”, then press 
or ENTER.
2 Press 
or 
to select “Auto Ch Memory”, then press 
or ENTER.
3 Press 
or 
to select “Signal Type”.
4 Press 
or 
to select “Air” or “Cable”.
Air - VHF/UHF channels
Cable - CABLE TV channels
CH Auto Ch Memory
| Signal Type | Cable |
|
| Automatic Search | Start | |
|
|
|
|
| :Select | :Adjust | |
CABLE CHART
The chart below is typical of many cable system channel allocations.
NOTE:
• It may take a few seconds for a digital channel picture to appear on screen after being selected.
Automatic Search
1 Select “Channel”, then press 
or ENTER.
2 Press 
or 
to select “Auto Ch Memory”, then press 
or ENTER.
3 Press 
or 
to select “Automatic Search”, then press 
or ENTER.
CH Auto Ch Memory
Signal Type | Cable |
Automatic Search | Stop |
Analog Channel Found : 0
Digital Channel Found : 0
Programming Now
:Select | ENTER :Cancel |
4 The TV will begin memorizing all the channels available in your area.
• It may take from 15 minutes to 30 minutes to complete memorizing digital cable channels. Depending on the reception condition, a bar display may not advance for several minutes, please be patient.
NOTE:
• Memorizing channels is best accomplished during evening “PRIMETIME” hours, as more stations are broadcasting digital signals. Memorizing channels can only be accomplished while a station is broadcasting a digital signal to set that channel into memory.
• If you are unsure of the digital channels available in your area, you may visit www.antennaweb.org to receive a list based on your address or zip code. Should you require further assistance you may call our
• New digital channels may be added to your area periodically, it is recommended to perform the “Automatic Search” procedure regularly.
Adding Channel
If you find a new digital channel unregistered, you can add the new channel into the channel memory.
1 Tune in the new channel.
2 Select “Channel”, then press 
or ENTER.
3 Press 
or 
to select “Add/Delete”, then press
or ENTER.
CH Add/Delete
|
| Adding Channel | >> |
|
| |
|
| Add/Delete |
| >> |
|
|
|
| Clear All |
| >> |
|
|
|
|
|
|
|
|
|
|
| :Select |
| ENTER :Set |
| |
Press | or | to select “Adding Channel”, then | ||||
4 press | or ENTER. The new channel will be | |||||
added into the channel memory.
Add/Delete channel
You can select the channel that you want to skip.
1 Select “Channel”, then press 
or ENTER.
2 Press 
or 
to select “Add/Delete”, then press
or ENTER.
3 Press 
or 
to select “Add/Delete”, then press
or ENTER.
4 Press 
or 
to select the channel that you want to skip.
CH Add/Delete
CH
Add
Add
Delete
Add
Delete
5 Press or to select “Add” or “Delete”, whichever function you want to perform.
6 Repeat steps 4 - 5 for other channels you want to add or delete.
18
