Sansui SLED3900A owner manual To connect a Hdmi or a DVI device to the unit

Connections to other equipment

To connect a HDMI or a DVI device to the unit

The HDMI input receives digital audio and uncompressed video from a HDMI device or uncompressed digital video from a DVI device.

When you connect to a DVI device with a HDMI-to-DVI adapter cable, it transfers only video signal. Separate analog audio cords required.

Rear and Right of the unit	HDMI cable (type A connector)		To HDMI output
To PC/DVI AUDIO IN
		(not supplied)		HDMI device
	To HDMI IN	HDMI - to - DVI adapter cable		or
		(HDMI type A connector)
		(not supplied)		DVI device
	Audio cord (not supplied)		To DVI output

NOTE:

• When using HDMI1/DVI IN to connect your HDMI or DVI devices, you must select the corresponding audio input source (HDMI or DVI) on the menu screen (see page 17). Otherwise you will only see the image with no sound.

To connect the TV to a PC (Personal Computer)

BEFORE YOU CONNECT THIS TV TO YOUR PC, CHANGE THE ADJUSTMENT OF YOUR PC’S RESOLUTION AND REFRESH RATE (60 HZ).

Connect one end of a (male to male) VGA cable to the video cord of the computer and the other end to the VGA connector PC MONITOR IN on the rear of the TV. Attach the connectors firmly with the screws on the plug. In case of a Multimedia computer, connect the audio cord to the audio output of your Multimedia computer and to the AUDIO IN connector of the PC/DVI AUDIO IN jack of the TV.You can also connect the PC with HDMI cable. If you use HDMI cable, you don’t have to connect the audio cord. If you use DVI-to-HDMI cable, please connect audio cord as same way as VGA cable.

Press INPUT SELECT on the remote control to select PC mode.

Switch on the computer. The TV can operate as the computer monitor.

Rear and Right of the unit			Monitor Display modes
			Mode	Resolution	Refresh rate
			VGA	640x480	60/ 72/ 75 Hz
			VGA	720x400	70Hz
To			SVGA	800x600	56/ 60/ 72/ 75 Hz
		To HDMI IN	XGA	1024x768	60/ 70/ 75 Hz
PC/DVI			WXGA	1280x768	60Hz
AUDIO			WXGA	1280x720	60Hz
IN	To PC
			WXGA	1360x768	60Hz
	MONITOR	HDMI cable (not supplied)	SXGA	1280x1024	60Hz
	IN
		VGA cable (not supplied)	WXGA+ 1440x900		60Hz
		Audio cord (not supplied)	FHD	1920x1080	60Hz
			To return to normal mode

NOTE:

Press INPUT SELECT again.

• The on-screen displays will have a different appearance in PC mode than in TV mode.

• If there is no video signal from the PC when the unit is in PC mode, “No signal” will appear on the TV-screen.

• When the PC’s resolution is set to 1920 x 1080/60 Hz (FHD mode), a signal that differs from the FHD signal, which has been confirmed operational on this TV, may appear depending on the PC used. In this case, “Auto Adjust” or other Position Adjustment functions may fail to correct the image position.

To solve this problem, change the PC settings to select another resolution.

EN 14