Sanus Systems TV-VCR, TV20, TV13 manual Using the TV27 or TV32 use the rear Pilot Hole, Step

Step 1:	Phillips Screw
Remove the swivel from the TV Turntable by removing the	Bottom of
Phillips Screw in the center of the swivel as shown in the Dia-	Turntable
gram to the right.

Step 2:
Use the same Phillips Screw removed from Step 1 to fasten the	Phillips Screw
swivel to the base of the TV-VCR Kit. Insert the Phillips screw
through the center hole of the swivel and proceed to thread it		TV-VCR Kit Base
into the appropriate pilot hole in the center of the TV-VCR
Kit as shown in the Diagram on the right. Tighten the Phillips
Screw with a phillips screw driver until tight.
NOTE: When using the TV20 use the front Pilot Hole. When	Front Pilot Hole	Rear Pilot Hole
Using the TV27 or TV32 use the rear Pilot Hole.
Step 3:	Plastic Dowels	Larger Hole

Insert the Plastic Dowels into the larger holes in the Support

Pillar as shown in the Diagram on the right. Gently tap the Plas- Support Pillar tic Dowels in with a hammer if needed. Repeat step for the

other Support Pillar.

Step 4:
Thread the Allen Bolts up through the Base of the TV-VCR Kit,	Top of TV-VCR Base
and into the corresponding holes in the Support Pillar. Tighten
Allen Bolts with the provided Allen Key until they are tight.

	Nylon Swivel is
Allen Bolts	Located on the Bottom
Step 5:	Top of TV Turntable
Add the TV Turntable to the TV-VCR Kit by setting the Turn-
table on top of the Support Pillars so the dowels in the Support	Plastic
Pillars line up with the holes in the bottom side of the turntable.	Dowel
Press the Turntable down firmly until the bottom of the Turn-
table is flush with the top of the Support Pillars.
Top of TV-VCR Kit	Front of Assembly
Sanus Systems 2221 Highway 36 W. St. Paul, MN 55113
800.359.5520 www.sanus.com 7.6.04