28
Press the Point ed buttons to select the Image adj. Menu
and press the Point 8 or OK buttons to access the submenu
items.
1
2Use the Point ed buttons to select the desired item and
press the Point 8 or OK buttons to access the selected item.
The adjustment bar is displayed.
Image adj. Menu
Press the Point 7 button to decrease the contrast; press the Point
8 button to increase the contrast (from -31 to +31).
Contrast
Press the Point 7 button to decrease the brightness; press the
Point 8 button to increase the brightness (from -31 to +31).
Brightness
Press the Point 7 button to decrease the intensity of the color;
press the Point 8 button to increase the intensity of the color
(from -31 to +31).
Use the Point 7 8 buttons to adjust the tint value to obtain a
proper color balance (from -31 to +31).
Color
Tint
Use the Point 7 8 buttons to select the desired Color temp. level
(High2, High1, Default, Low1, or Low2). Default is based on the
currently set image mode (p.27).
Color temp.
IMAGE ADj. button
Direct Operation
Press the IMAGE ADJ. button on the remote control to display
the adjustment bar of Image adj. Menu items one at a time and
directly adjust the selected item.
Use the Point ed buttons to select the desired item and the Point
7 8 buttons to adjust the setting. Press the MENU button after
adjusting.
If you press the OK button after adjusting each item, it will enter
the main menu.
Menu Operation
Remote Control
3Use the Point 7 8 buttons to adjust the setting values and
press the OK button.
Image mode can be adjusted for each input source and the adjustment is kept until the projector is turned off or the image
mode is changed.
✔Note:
 •TintcannotbeselectedwhenthevideosystemisPAL,SECAM,
PAL-M,orPAL-NinVideoinputorS-videoinput.
 •TheImageadj.Menucannotbeoperatedwithoutaninputsignal.
Go on to the next page....
Image Adjustment

Image Mode Adjustment

When Advanced menu is set to Off.
When Advanced menu is set to On.
Brightness ➜ Contrast ➜ Color ➜ Tint ➜ Color
temp. ➜ Red ➜ Green ➜ Blue ➜ Sharpness ➜
Lamp control ➜ Gamma ➜ Progressive ➜ Noise
reduction ➜ Brightness ➜ • • • •
Brightness ➜ Contrast ➜ Color ➜ Tint ➜ Color
temp. ➜ Red ➜ Green ➜ Blue ➜ Sharpness
➜ Lamp control ➜ Gamma ➜ Progressive ➜
Noise reduction ➜ Iris mode ➜ Iris range ➜
Auto black stretch➜ Contrast enhancement ➜
Transient improvement ➜ Color management ➜
Dynamic gamma ➜ 3D-Y/C ➜ Custom gamma ➜
Brightness ➜ • • • •
✔Note:
 •3D-Y/Cmaynotappeardependingontheinput
signal.
✔Note:
 •AboveimageisanexampleofwhentheImage
modeissetto“Natural.”Eachvaluevaries
dependingontheselectedImagemode(p.27).