5 ADJUST PROJECTION MIRROR
When the figure of the projection image does not match the Projection Screen, adjust the Projection Mirror. If the figure fits the Projection Screen precisely, skip the steps 2, 3 and 4 and replace the Back Cover.
1Check Projection Image
Connect the projector to the AC outlet, and turn the projector on. Connect the video output equipment to the projector. Project the image of
If the figure is distorted, adjust the Projection Mirror following the steps 2 to 4 below.
If the picture is displayed properly, adjustment of the Mirror is not required. Skip the steps below and replace the back cover.
Screw(B)
Mirror Holder
2Adjust Projection Mirror
Adjust the Projection Mirror by turning the Adjusting Nuts. Move the Projection Mirror up or down by turning the Adjusting Nuts on the both sides of the Projection Mirror. Adjust Screw(B) if it required.
Refer to the figure on the right for the image movement with the Adjusting Nut.
3Fix Projection Mirror
Fix the Projection Mirror where the picture is displayed properly. Fix the Screw(B) securely. When fixing the Screw(B) the figure may be distorted again. When it should happen, readjust the Mirror following the steps 2 to 4.
4Turn the projector off
Turn off the projector and disconnect it from the AC outlet.
CAUTION
DO NOT STARE DIRECTLY INTO THE LENS. EYE DAMAGE COULD RESULT. WHEN ADJUSTING THE MIRROR, NEVER TOUCH THE PARTS EXCEPT THE
MIRROR. IT MAY RESULT IN ELECTRICAL SHOCK.
Lower the | Lift the Mirror |
Mirror Holder. | Holder. |
Mirror Arm | Adjusting Nut |
Turn Adjusting Nuts to adjust the screen image.
When turning the Adjusting Nuts on both sides to the right, the lower part of the image becomes narrow.
When turning the Adjusting Nuts on both sides to the left, the lower part of the image is stretched.
When turning the Adjusting Nuts on one side to the left or the right, one side of the lower part of the figure is shortened or stretched.