|
|
|
|
| CAUTION |
| THIS SYMBOL INDICATES THAT DANGEROUS VOLTAGE CONSTITUTING A |
|
|
| |
|
|
| RISK OF ELECTRIC SHOCK IS PRESENT WITHIN THIS UNIT. |
| RISK OF ELECTRIC SHOCK DO NOT OPEN! | ||
|
|
| |
|
|
|
|
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR |
| THIS SYMBOL INDICATES THAT THERE ARE IMPORTANT OPERATING AND | |
BACK). NO |
| MAINTENANCE INSTRUCTIONS IN THE LITERATURE ACCOMPANYING THIS | |
VICE PERSONNEL. |
| UNIT. | |
|
|
|
|
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
IMPORTANT SAFETY INSTRUCTIONS
FCC INFORMATION
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna. |
– Increase the separation between the equipment and receiver. |
1. | Read these instructions. |
2. | Keep these instructions. |
3. | Heed all warnings. |
4. | Follow all instructions. |
5. | Do not use this apparatus near water. |
6. | Clean only with dry cloth. |
15. If an outside antenna is connected to the television |
equipment, be sure the antenna system is grounded so |
as to provide some protection against voltage surges |
and built up static charges. In the U.S. Selection |
of the National Electrical Code provides information with |
respect to proper grounding of the mast and supporting |
structure, grounding of the |
– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. |
– Consult the dealer or an experienced radio/TV technician for help. |
CAUTION: FCC Regulations state that improper modifications or unauthorized changes to this unit may void the user’s authority to operate the unit.
7. | Do not block any ventilation openings. Install in |
| accordance with the manufacturer’s instructions. |
8. | Do not install near any heat sources such as radiators, |
| heat registers, stoves, or other apparatus (including |
| amplifiers) that produce heat. |
9. | Do not defeat the safety purpose of the polarized or |
| |
| one wider than the other. A |
| blades and a third grounding prong. The wide blade or the |
| third prong are provided for your safety. If the provided |
| plug does not fit fully into your outlet, consult an electri- |
| cian for replacement of the obsolete outlet. |
10. Protect the power cord from being walked on or | |
| pinched particularly at plugs, convenience receptacles, |
| and the point where they exit from the apparatus. |
11. Only use attachments/accessories specified by the | |
| manufacturer. |
12. | Use only with the cart, stand, tripod, |
| bracket, or table specified by the manu- |
| facturer, or sold with the apparatus. |
| When a cart is used, use caution when |
| moving the cart/apparatus combination |
| to avoid injury from |
13. Unplug this apparatus during lightning storms or when | |
| unused for long periods of time. |
discharge unit, size of grounding conductors, location of |
antenna discharge unit, connection to grounding elec- |
trodes, and requirements for the grounding electrodes. |
16. An outside antenna system should not be located in the |
vicinity of overhead power lines or other electrical light |
or power circuits, or where it can fall into such power |
lines or circuits. When installing an outside antenna |
system, extreme care should be taken to keep from |
touching such power lines or circuits as contact with |
them might be fatal. |
EXAMPLE OF ANTENNA GROUNDING ACCORDING
TO NATIONAL ELECTRICAL CODE, ANSI/NFPA 70
“Note to CATV system installer:
This reminder is provided to call the CATV system installer’s attention to Article
TRADEMARKS
Manufactured under license from Dolby Laboratories. “Dolby” is a trademark of Dolby Laboratories.
HDMI, the HDMI Logo and
“As an Energy Star® Partner, Sanyo Manufacturing Corporation has deter- mined that this product meets the Energy Star® guidelines for energy efficiency.”
This symbol on the nameplate means the product is Listed by Underwriter’s Laboratories Inc. It is designed and manufactured to meet rigid U.L. safety standards against risk of fire, casualty and electrical hazards.
This Class B digital apparatus complies with Canadian
SANYO recommends keeping the TV set at its
PC RESOLUTION CHART
14. Refer all servicing to qualified service personnel. | 17. | Wall or Ceiling | |||
| Servicing is required when the apparatus has been |
| mounted to a wall or ceiling only as recommended by | ||
| damaged in any way, such as |
| the manufacturer. | ||
| plug is damaged, liquid has been spilled or objects have | 18. | Apparatus shall not be exposed to dripping or splashing | ||
| fallen into the apparatus, the apparatus has been |
| and no objects filled with liquids, such as vases, shall be | ||
| exposed to rain or moisture, does not operate normally, |
| placed on the apparatus. | ||
| or has been dropped. |
|
| 19. | When the MAINS plug is used as the disconnect device, |
|
|
|
| ||
|
|
|
|
| the disconnect device shall remain readily operable. |
2 | Need help? | www.sanyoctv.com | |||
factory settings or moving Energy Saver settings from “Level 1” to “Level 2” or “Level 3” to further reduce power requirements and increase energy savings. Doing so contributes to the sustainability of our resources and environment.
For more information visit www.energystar.gov
Need help?
CONTAINS MERCURY LAMPS,
DISPOSE OF PROPERLY
www.sanyoctv.com 
