STAND BASE ASSEMBLY

NOTE: Do not assemble the stand base if you are wall mounting the HDTV.

Tools Needed: Phillips screwdriver No. 3

IMPORTANT NOTE:

Place HDTV face down on a padded or cushioned surface that is larger than the screen size to protect the screen and finish. Handling by more than two people is recommended.

1 Carefully insert the stand base to the bottom of the HDTV as shown.

2 Secure the stand base with the two (2) screws supplied in the literature package.

WALL MOUNTING

CAUTION: Wall mounting of the HDTV must be performed by a skilled person.

Use the screws that are threaded into the four (4) inserts on the back of your Plasma HDTV to secure it to a wall mounting kit (not included.)

UNIVERSAL standard interface: 400 x 280

Mounting screws measurements:

M6 Diameter, Length—12mm (max.)

GETTING STARTED

BATTERY INSTALLATION

Install two (2) “AAA” batteries in the remote control. (Not included)

To ensure safe operation, please observe the following precautions:

Replace both batteries at the same time. Do not use a new battery with a used battery.

There’s a risk of explosion if a battery is replaced by an incorrect type.

Do not expose the Remote Control unit to moisture or heat.

Be sure to match the “+” and signs on the batteries with marks inside the remote control.

ANTENNA CONNECTION FOR OFF-AIR SIGNALS OR CABLE

Hook up your antenna or your cable service to the HDTV’s ANT terminal with the use of a 75 OHM coaxial cable.

NOTE: Keep your indoor antenna at least 3 ft. away from the television set and any other electronic equipment.

ANTENNA

ANALOG / DIGITAL

ANTENNA IN

CABLE

The tuner in this HDTV can receive:

Digital and Analog off air signals from an antenna

Analog or ClearQAM cable channels from a direct Cable TV connection.

HDTV BACK

Need help? www.sanyoctv.com 1-800-877-50325

Page 5
Image 5
Sanyo DP42740 manual Getting Started, Stand Base Assembly, Wall Mounting, Battery Installation