STAND REMOVAL AND WALL MOUTING (OPTIONAL)

Tools Needed: Phillips screwdriver No. 3

IMPORTANT NOTE:

Place HDTV face down on a padded or cushioned surface to protect the screen and finish. Wall mounting of the HDTV must be performed by a skilled person.

DP42849

DP46849 DP52449

1Remove the four (4) screws securing the foot stand. CAUTION: Hold the stand firmly as you remove the last screw.

2Use the screws you removed when detach- ing the stand to secure the HDTV to a wall mounting kit (kit not included.)

VESA standard interface: 400 x 400

Mounting screws measurements:

M6 (6mm) Diameter, Length—16mm (maximum)

GETTING STARTED

Install batteries in the remote control ( 2 “AAA”, not included)

PRECAUTIONS

To ensure safe operation, please observe the following precautions:

Replace both batteries at the same time. Do not use a new battery with a used battery.

There’s a risk of explosion if a battery is replaced by an incorrect type.

Do not expose the Remote Control unit to moisture or heat.

Be sure to match the “+” and signs on the batter- ies with marks inside the remote control.

Need help?

1Remove the four (4) screws securing the foot stand. CAUTION: Hold the stand firmly as you remove the last screw.

2Use the screws you removed when detach- ing the stand to secure the HDTV to a wall mounting kit (kit not included.)

VESA standard interface: 400 x 400

Mounting screws measurements:

M6 (6mm) Diameter, Length—16mm (max.)

ANTENNA CONNECTION FOR OFF-AIR SIGNALS OR CABLE

ANTENNA

ANALOG / DIGITAL

ANTENNA IN

CABLE

Note: The tuner in this HDTV can receive digital and analog off air signals from an antenna. It can also receive analog or ClearQAM cable channels from a direct Cable TV connection.

www.sanyoctv.com 1-800-877-50325

Page 5
Image 5
Sanyo DP52449 Stand Removal and Wall Mouting Optional, Getting Started, Antenna Connection for OFF-AIR Signals or Cable