|
|
|
|
| CAUTION |
| THIS SYMBOL INDICATES THAT DANGEROUS VOLTAGE CONSTITUTING A |
|
|
| |
|
|
| RISK OF ELECTRIC SHOCK IS PRESENT WITHIN THIS UNIT. |
| RISK OF ELECTRIC SHOCK DO NOT OPEN! | ||
|
|
| |
|
|
|
|
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER | THIS SYMBOL INDICATES THAT THERE ARE IMPORTANT OPERATING AND | ||
(OR BACK). NO | MAINTENANCE INSTRUCTIONS IN THE LITERATURE ACCOMPANYING THIS | ||
SERVICE PERSONNEL. |
| UNIT. | |
|
|
|
|
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
IMPORTANT SAFETY INSTRUCTIONS
1. | Read these instructions. | 15. If an outside antenna is connected to the television | |
2. | Keep these instructions. | equipment, be sure the antenna system is grounded so | |
as to provide some protection against voltage surges | |||
3. | Heed all warnings. | ||
and built up static charges. In the U.S. Selection | |||
4. | Follow all instructions. | of the National Electrical Code provides information with | |
5. | Do not use this apparatus near water. | respect to proper grounding of the mast and supporting | |
structure, grounding of the | |||
6. | Clean only with dry cloth. | ||
discharge unit, size of grounding conductors, location of | |||
7. | Do not block any ventilation openings. Install in | antenna discharge unit, connection to grounding elec- | |
trodes, and requirements for the grounding electrodes. | |||
| accordance with the manufacturer’s instructions. | ||
| 16. An outside antenna system should not be located in the | ||
8. | Do not install near any heat sources such as radiators, | ||
vicinity of overhead power lines or other electrical light | |||
| heat registers, stoves, or other apparatus (including | ||
| or power circuits, or where it can fall into such power | ||
| amplifiers) that produce heat. | ||
| lines or circuits. When installing an outside antenna | ||
9. | Do not defeat the safety purpose of the polarized or | ||
system, extreme care should be taken to keep from |
FCC INFORMATION
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installa- tion. This equipment generates, uses and can radiate radio fre- quency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio com- munications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
–Reorient or relocate the receiving antenna.
–Increase the separation between the equipment and receiver.
–Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
–Consult the dealer or an experienced radio/TV technician for help.
CAUTION: FCC Regulations state that improper modifications or unauthorized changes to this unit may void the user’s authority to operate the unit.
TRADEMARKS
Manufactured under license from Dolby Laboratories. “Dolby” is a trademark of Dolby Laboratories.
HDMI, the HDMI Logo and
“As an Energy Star® Partner, Sanyo Manufacturing Corporation has deter- mined that this product meets the Energy Star® guidelines for energy efficiency.”
This symbol on the nameplate means the product is Listed by Underwriter’s Laboratories Inc. It is designed and manufactured to meet rigid U.L. safety standards against risk of fire, casualty and electrical hazards.
This Class B digital apparatus complies with Canadian
| touching such power lines or circuits as contact with | ||||
| one wider than the other. A | them might be fatal. | |||
| blades and a third grounding prong. The wide blade or the | EXAMPLE OF ANTENNA GROUNDING ACCORDING | |||
| third prong are provided for your safety. If the provided | TO NATIONAL ELECTRICAL CODE, ANSI/NFPA 70 | |||
| plug does not fit fully into your outlet, consult an electri- |
| |||
| cian for replacement of the obsolete outlet. |
|
| ||
10. Protect the power cord from being walked on or |
| ||||
| pinched particularly at plugs, convenience receptacles, |
| |||
| and the point where they exit from the apparatus. |
|
| ||
11. Only use attachments/accessories specified by the |
| ||||
| manufacturer. |
|
| “Note to CATV system installer: | |
12. Use only with the cart, stand, tripod, |
| ||||
| This reminder is provided to call the CATV system installer’s attention to | ||||
| bracket, or table specified by the |
| Article | ||
|
| and, in particular, specifies that the cable ground shall be connected to | |||
| manufacturer, or sold with the appara- |
| the grounding system of the building, as close to the point of cable entry | ||
| tus. When a cart is used, use caution |
| as practical.” | ||
|
| 17. Wall or Ceiling | |||
| when moving the cart/apparatus com- |
| |||
| bination to avoid injury from |
| mounted to a wall or ceiling only as recommended by | ||
13.Unplug this apparatus during lightning storms or when | the manufacturer. | ||||
18. Apparatus shall not be exposed to dripping or splashing | |||||
| unused for long periods of time. |
| |||
14. Refer all servicing to qualified service personnel. Servicing | and no objects filled with liquids, such as vases, shall be | ||||
placed on the apparatus. | |||||
| is required when the apparatus has been damaged in any | ||||
| 19. Where the Mains plug is used as the disconnect device, | ||||
| way, such as | ||||
| has been spilled or objects have fallen into the apparatus, | the disconnect device shall remain readily operable. | |||
| the apparatus has been exposed to rain or moisture, does | 20. A warning that an apparatus with Class1 construction | |||
| not operate normally, or has been dropped. |
| shall be connected to a Mains socket outlet with a | ||
|
|
|
| protective earthing connection. | |
2 | Need help? | www.sanyoctv.com | |||
PC RESOLUTION CHART
SANYO recommends keeping the TV set at its factory settings or moving Energy Saver settings from “Level 1” to “Level 2” or “Level 3” to further reduce power requirements and increase energy savings. Doing so contributes to the sustainability of our resources and environment.
For more information visit www.energystar.gov
SPECIFICATIONS
Power Requirement: Source – AC 120V, 60Hz
AC Power Consumption: 464 watts
Weight: 84 lbs.
Dimensions: | WIDTH | HEIGHT | DEPTH |
DP50719 | 49.0 | 33.1 | 14.2 |
w/o stand |
| 30.3 | 4.7 |
NOTE: Dimensions are in inches
Need help? www.sanyoctv.com 
