INSTALLATION

Sleeve

L Key

metal strap to a solid metal part of the vehicle under the dashboard. This strap also helps ensure proper electrical

R Key

grounding of the unit.

Spring Washer

Metal Strap

Mounting Bolt

Hex Nut

4. Mount the sleeve by inserting the sleeve

into the opening of the dashboard and

bend open the tabs located around the

sleeve with a screwdriver. Not all tabs

will be able to make contact, so

examine which ones will be most

effective. Bend open the appropriate

tabs behind the dashboard to secure

the sleeve in place.

Dashboard

Tabs

Screwdriver

5.Reconnect the wire harness and the antenna and be careful not to pinch any wires or cables.

6.Slide the unit into the sleeve until it locks into place.

7.To further secure the unit, use the supplied metal strap to secure the back of the unit in place. Use the supplied hardware (Hex Nut (M5mm) and Spring Washer) to attach one end of the strap to the mounting bolt on the back of the unit. If necessary, bend the metal strap to fit your vehicle's mounting area. Then use the supplied hardware (Tapping Screw (5x25mm) and Plain Washer) to attach the other end of

Plain Washer

Tapping Screw

8.Reconnect the cable to the vehicle battery's negative (-) terminal.

Removing the unit

1.Make sure the ignition is turned off, then disconnect the cable from the vehicle battery’s negative (-) terminal.

2.Remove the metal strap attached the back of the unit (if attached).

3.Insert the release frame key into the groove at the right side of the frame, then prize out to remove the frame.

(You can also use the key to remove the frame from the left side.)

Frame

4.After releasing the frame, insert the release unit keys supplied with the accessory into the grooves at both sides of the unit as shown in figure until they click. Pulling the keys makes it possible to remove the unit from the dashboard.

4