OPERATION

SWITCHING ON/OFF THE UNIT

When the hidden panel turns up (in State 2), switch the unit on by pressing any button (except button (4)). When system is on, press (9) to turn the unit off.

SOUND ADJUSTMENT

Press SEL button (10) to select the desired adjustment mode.

The adjustment mode will change in the following order:

VOL BAS TRE BAL FAD

(Volume) (Bass) (Treble) (Balance) (Fader)

By pressing VOLUME + button (11) or VOLUME- button (27), it is possible to adjust the desired sound quality.

BEEP ADJUSTMENT

Press SEL button (10) and hold for more than 2 seconds until “BEEP“ appears on display.

Press VOLUME+ button (11) or VOLUME- button (27) as follows:

BEEP 2ND BEEP ALL BEEP OFF

SET THE CLOCK

Press the DSP button (15), the clock is shown on the LCD display. Then hold down the button until the clock flashes. Then press the MANU/SKIP button (17) to change hours or MANU/SKIP button (16) to change minutes.

MUTE

Press MUT button (2) to mute down the sound instantly. If any button (except button (4)) is pressed in the mute state, the mute mode is released.

EQUALIZATION

Press EQ button (24) to turn on equalization function and to select desired audio mode. There are five kinds of mode as below:

FLATCLASSICS POP MROCK M DSP OFF

LIQUID CRYSTAL DISPLAY

Exhibit current frequency and activated functions on the display (8).

AUXILIARY INPUT

The unit can be connected to a portable audio player through the AUX IN jack (7). Note : The face plate will not close when something is plugged in the AUX in jack.

-BEEP 2ND mode:

The beep is only generated when all allowed double function button is pressed long (several seconds). e.g. When preset button is pressed. When BND/LOU button (13) is pressed.

When AMS button (18) is pressed.

-BEEP ALL mode:

The beep is generated when every button is pressed.

-BEEP OFF mode: The beep is disabled.

REMOTE SENSOR

Point the remote control handset to the remote sensor IR (23). Press the function keys on the handset to control the system.

RESET FUNCTION

RESET button (12) can be activated with either a ballpoint pen or thin metal object. The RESET button is to be activated for the following reasons:

-Initial installation of the unit when all wiring is completed.

-All the function buttons do not operate.

-Error symbol on the display.

9