OPERATION

button repeatedly can select three kinds of repeat play modes.REP-ONE:Play the same song over and over again.FOLDER REP:Play all songs in the current directory in sequence, over and over again.FOLDER:Play all songs in the current directory once.

When select PLAY MODE, press / to change between the following mode:

SINGLEREP-ONEFOLDER FOLDER REP DISC SCANDISCDISC REPRANDOM SHUFFLE ONPROGRAM PXXX

During playback,use or to skip an item ahead or back. : Rapid reverse, : Rapid advance

Note: The FOLDER cannot be selected during playing. It can be selected after (Stop) button pressed.

RADIO OPERATIONSwitching to radio mode

Press MODE button on remote control to select radio mode. In radio mode, the following information will appear on the display.

FM1 98.1 MHzMONO

VOLUME

 

40

 

M1

87.50

BASS

-2

 

M2

90.10

TREBLE

-2

 

M3

98.10

BALANCE

L-R

M4

106.10

FADER

F-R

M5

108.00

LOUD

OFF

M6

87.50

EQ

POP

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Selecting the frequency band

Press BAND on remote control to select desired band. The reception band will change in the following order:

FM1 FM2 FM3 AM1 AM2

Selecting station

During radio mode, press CH button on remote control to increase frequency or CH button on remote control to decrease frequency by one step of channel spacing. Hold the button longer for fast tuning. The frequency is updated correspondingly on display.

Setting memory

Press RADIO PRESET buttons (1~6) on remote control to preset stations at radio mode. With this system, a total of 30 stations can be stored in the memory of six buttons. Each band stores up to six preset stations. The stations might be FM1, FM2, FM3, AM1 and AM2 band.

The operation is as below:

-Store in Memory Press and hold desired memory location button for several seconds. The current listening station will be stored into the number button.

-Retrieve a Preset Station Press any one of the RADIO PRESET buttons (1~6) on remote control to retrieve a station which had been stored in the memory in advance the chosen number is shown on display.

Automatic memory storing & program scanning

-Automatic memory storing Press GOTO (AS/PS) button on remote control for several seconds, the radio searches from the current frequency and checks the signal strength until one cycle search is finished. And then 6 strongest stations are stored into the corresponding preset number button.

-Program scanningPress GOTO (AS/PS) button on remote control shortly to scan preset station.

25