Lens Adjustment■Fine-adjusting focus (using buttons provided on side face)

3

NEAR FAR

RESET

2

SET

1Use the zoom lever of the lens to adjust the angle of view and the focus lever of the lens to roughly focus on the subject.

2Press the SET button. (Focus adjustment screen Page 7)

The camera automatically focuses on the subject. Note that the color of the status indicator B “FOCUSING” turns from black to orange.

If the camera failes to focus on the subject, the FA bar A will not operate normally

with the status indicator B showing “ERROR”. In this case, manually adjust the focus. ( Electronic manual)

3Press the NEAR/FAR button to adjust the focus.

Pressing the button causes the back focus position to change, which is indicated in the FB bar gauge C.

The position changes step by step each time the button is pressed and continuously at a high speed when the button is held down.

If you want to restore the default back focus position in re- adjustment, etc., press the NEAR and FAR buttons simultaneously. While the camera is initializing the back focus position, the status indicator B shows “INITIALIZING”.

4Press the SET button for 2 seconds or more.

The focus adjustment screen will close and the SELECT MENU screen reappears.

•The focus adjustment screen will also close automatically if left idle for 5 minutes or more.

•VCC-HD2500P/HD2500/HD2300P/HD2300:

Adjust the focus using the following procedure when the camera fails to focus on the subject in color or black-and-white mode.

①Select [FOCUS ASSIST] on the CAMERA SETTINGS screen and make sure that “AUTO” is set for [COLOR/B/W].

②Adjust the focus in color or black-and-white mode.

8