How to connect the player to your PC
Pay attention to the direction of the terminal
Original USB cable (supplied)
Note:
-Do not use an USB hub or USB extension cable (Operation is not guaranteed). Use only the supplied USB cable for connection.
-When you connect the player to the PC for the first time, it sometimes may not be recognised as a Removable Disk. In this case, disconnect the player and reconnect it again.
1.Turn on your PC and Windows is started.
2.If the player is turned on, press [a/n z] (for at least 2 seconds) to turn the player off.
3.Connect the player to the PC with the USB cable.
When the player is connected to the PC, it automatically enters to the battery charging mode.
“
” is displayed on the display while charging. When
the charge is completed, “
” appears.
-Fully charge the battery before using the player for the first time.
-The battery is fully charged approximately 4 hours.
After connection, the following screen will appear. Example:
1) Select
3) Click
2) Check
Adjust your settings to match your PC’s environment. In this manual, [Take no action] is selected, [Always do the selected action] is checked, and [OK] is clicked. This completes the connection to the PC.
-For Windows Me/2000, this operation is not needed.
When connected to the PC, the player display will be as shown below and none of the operating buttons will work.
PC | PC |
Stop | Moving |
Connected to PC | Transmitting to/from PC |
Before disconnecting the player from the PC, be sure to follow the steps on page 8. Do not disconnect during data transfer.