LCD PROJECTOR LENS
MODEL
LENS REPLACEMENT PROCEDURE
NOTES ON LENS REPLACEMENT
Lens replacement should be performed by the qualified service personnel. It should be followed by this procedure precisely.
Before attempt to replace the lens, confirm the model number (both the LCD projector and the lens) and use the proper lens.
The lens cover is on the lens for protection. Be sure to remove the lens cover before installation.
When installing or removing the lens, be careful not to stain, scratch or damage the lens.
If you have any questions, contact the dealers.
PARTS LIST
Following parts are contained in the packing.
● LENS |
| 1 piece |
● DRIVER (3 mm, Green) |
| 1 piece (Part No. 610 287 7328) |
● DRIVER (4 mm, Yellow) |
| 1 piece (Part No. 610 275 6029) |
● |
| 1 piece Type PA1 (Part No. 610 285 3735) |
For |
| 1 piece Type PE1 (Part No. 610 293 9804) |
|
|
|
|
|
|
Following checks and confirmations should be taken for safety.
Check the following things by the time of the cabinet assembly after the lens replacement.
1.Check the lens is securely fixed.
2.Check the proper wiring and the wires are fixed properly.
3.Check each connector is connected properly.
4.Check no wiring is tangled on the gear of lens motor or the other mechanical parts.
5.Check no parts is missing, or no mounting part is loose.
