4Remove Lens Protection Cap from the rear (mounting side) of the Projection Lens and attach the lens Attachment to the lens with 4 Screws. (Use screws attached to the lens.) See Fig. 4.
LENS LOCK
LEVER
LENS ATTACHMENT
Lens Attachment 01
DRIVER INCLUDED
IN THE LENS PACKAGE (610 303 8742)
Part No. (610 275 6029)
Fig-4
LENS MOUNTING BRACKET
Fig-5
5 | Grasp (release lock) the Lens Lock Lever and turn it fully upward. (See Fig. 6) |
| |
| Mount the Lens into the lens mounting bracket and grasp the lens lock lever and turn it counter- |
| clockwise until the lever is locked. (See Fig. 5 and 7) |
| After installing the lens, make sure the lens is not loose and properly installed. |
6Set up the projector and project image on the screen. Turn the lens part "A" to adjust ZOOM. Turn the lens part "B" to adjust FOCUS.
LENS LOCK RELEASE
| Grasp (unlock) Lens | |
Grasp (unlock) | Lock Lever and fully | |
pulled downward until | ||
Lens Lock Lever | ||
it is locked (clicked). | ||
and pulling | ||
| ||
upward. |
|
LENS LOCK
Turn the lens part "A" to adjust ZOOM.
A
B
Fig-6
Turn the lens part "B" to adjust FOCUS.
LENS INSTALLATION NEEDS TWO OR MORE PEOPLE.
TO INSTALL THE LENS BY A SINGLE PERSON MAY RESULT IN A SERIOUS DAMAGE ON THE LENS OR THE PROJECTOR BY DROPPING OR BUMPING THE PRODUCTS.
